X10 DS11E DATASHEET

Product number : DS11E

Door / Window

Sensor

Door and Window Contact

Key Features

• Supervised door/window sensor (sends a
self checking signal every 90 minutes).

• Uses full 16 bit Code for RF transmission.

• Input for an extra wired sensor.

• Temper switch.

• Battery operated.

Benefits

The DS11E door/window sensor works with any X10

security system. This sensor sends a wireless radio

frequency signal to the main console when a door

(window) or/and the hard wired input are opened.

When the system is not armed, the console chimes

when a door (window) or/and the hard wired input

are opened. When the system is armed, the alarm is

tripped. A delay switch on the front of the door/window

sensor lets you select if an alarm is tripped

immediately, when the door (window) or/and the

hard wired input are opened, or after a preset entry

delay when the system is armed in delay mode.

The sensor sends a "self-checking" transmission

approximately every 90 minutes. The console will not

arm if a door/window sensor hasn't reported in or if

a door (window) is opened (can be overdriven by

pressing the console's Accept Button).

You can protect more than one door (window) from a

single sensor by installing additional magnetic

switches. Simply loop the switches in series from one

door (window) to the next (using any suitable wire),

and connect them to the wired input screw terminals

of the motion detector.

Technical data

• Batteries: 2 x AAA

• Operating life: 2 years using alkaline

batteries

• RF frequency: 433.92 MHz

• Radiated output: < 1mW

• RF operating range: 60 m (open field)

• Code for RF transmission: 16 bit (65536

different codes)

• Approvals: EN 300 220-3; EN 50 130-4;

EN 301 489-3; R&TTE, CE Mark

• Ambient temperature:

- 10° C to + 50° C (operation)

- 20° C to + 70° C (storage)

• Dimensions:

54 x 83 x 22 mm
(width x height x depth)

This sensor can also be used as a universal transmit-

ter: do not use the magnetic switch, connect to the

wired input screw terminals any kind of "normal

closed" detector you want, as low temperature, water

leak, smoke detector, etc.