X10 AW12E DATASHEET

Référence : AW12E

Wall appliance module

Key features

• Small enough (46 x46 x17 mm) to fit into a

wallbox behind a standard wallswitch.

• Works with any X10 controller

Avantages

The AW12E Micro Module can be mounted behind any

standard wall switch, even most designer switches.

It is an X10 receiver module that can be controlled by

any X10 controller or remote control sending X10

signals. The internal relay can also be tripped by

external latched or momentary action wall switches.

The AW12E reacts to STANDARD X10 protocols: "All

Units On", "All Units Off", "All Lights Off" from any X10

controller set to its house code, regardless of unit

code. Or alternatively, by individual unit control using

"On", "Off".

House code and unit code are programmed using any

X10 compatible controller. There is an E²PROM that

stores the house and unit code even when the power

is cut.

Technical datas

• Supply voltage: 230V +10% -15% 50 Hz

• Supply current : = 20 mA capacitive

• Making capacity:

- 2000W ( incandescent lamp)

- 3 A (motors)

- 16 A (resistive loads)

• Signal sensitivity: 15 mVpp min 50 mVpp
max at 120 kHz

• Input impedance: ≥180 Ohms (L - N) at

120 kHz

• Connections: screw type terminals for
phase, neutral and switched phase, wire
for switch connection

• Approvals: CE Mark

• Ambient temperature:

- 10° C to + 40° C (operation)

- 20° C to + 70° C (storage)

Typical applications

On/Off control of electrical loads.

• Dimensions: 46 x 46 x 17 mm