Wartsila Jovyline 625, Jovyline 1200, Jovyline 2200 Operating Manual

BAX 3522 E

Operating Manual

UPS Systems

Wärtsilä

JOVYLINE 625/1200/2200

UPS-Division

Operating Manual Wärtsilä JOVYLINE 625/1200/2200 BAX 3522 E page 2

Important information!

Please read this manual carefully before
installation.

Pay attention to each special hint within
the separate chapters to avoid later
disturbances of the device right from the
start.

In case of problems please contact our
Service department.

In favour of our environment:
Please preserve the packing in case a
servicing should arise or carry it to a
suited recycling circle.

UPS-Division

Operating Manual Wärtsilä JOVYLINE 625/1200/2200 BAX 3522 E page 3

Chapter Contents page
______________________________________________________________________________________

1. Technical Data 4

Table 1: type-specific data 4

2. Security 5

3. Description of the UPS-system 6

3.1 Preface 6

3.2 Description of the system 7

3.3 Front- and back views of the Wärtsilä JOVYLINE 625/1200/2200 7

4. Installation 11

5. Operation of the UPS-system 12

6. Alarms 13

7. Software options 13

8. Computer interface connection 14

9. Replacing of batteries 14

10. Troubleshooting 15

______________________________________________________________________________________

Attention!

Please inspect the contents of the packing for damages in transit and completeness
right away after delivery.

Delivery accessories UPS JOVYLINE 625 / 1200 / 2200
1 pc. OFFLINE UPS-system
1 pc. Mains cable, grey/white interface cable, two-poled connection cable

for analogous modem/telephone - connection

UPS-Division

Operating Manual Wärtsilä JOVYLINE 625/1200/2200 BAX 3522 E page 4

1. Technical data

1.1 Table 1: Typespecifical data

UPS (nominal power) 625 VA 1200 VA 2200 VA
Input voltage / mains voltage 230 V +20% -25%
Mains frequency

50 / 60 Hz



5% (automatic switch-over)

Output voltage 230V
Output frequency

50 / 60 Hz



0,5% (at battery operation)

Voltage regulation of the output
voltage

AVR increases the output voltage by 15% over input voltage, if the
input voltage sinks within –9% up to – 25%. AVR decreases the output
voltage by 13% compared with the input voltage, if the input voltage
increases within +9% up to +25%

Time for switch over 2-4 ms including detection time
10 Base-T Cable Port network (UTP, RJ-45) compatible plugs
Protection against spikes 320 Joule, 2ms
Overload protection UPS switches off after 110% overload for 60 sec. and

130% overload for 3 sec.

Short circuit protection UPS switches off immediately or input protection gets released
Input protection Protection against overload and short circuit

Type of battery Lead battery, closed maintenance-poor

12V / 7Ah (JOVYLINE 625) 24V / 7Ah (JOVYLINE 1200 /

JOVYLINE 2200)

Charging duration battery 4 hours up to 90% of nominal capacity
Protection installations battery Automatic selftest and protection against discharging, display for

defect batteries

Autonomy time 10-30 min. (in dependency on the computer load)
Weight UPS 6,5 kg 13,4 kg 15,9 kg

Dimension (w x h x d) in mm 97 x 320 x 135 130 x 382 x 192 130 x 382 x 192
Mains input connection Connection acc. IEC 320

Alarm, battery charging Slow bleeping tone (ca. 0,47Hz)
Alarm, battery discharged Quick bleeping-tone (ca. 1,824Hz)
Alarm, overload Permanent sound
Interface RS-232 Bi-directional com. Port
Rules for construction security: VDE, TÜV, CE ,
Surrounding terms

Placing

1000m above sea level acc. to EN 62040-3

Surrounding terms
General

humidity 0 - 95% non condensing, acc. to table DIN 40040

0-48°C

Decibel level acc. to ISO 7779 < 40 dbA

Technical modifications be possible

UPS-Division

Operating Manual Wärtsilä JOVYLINE 625/1200/2200 BAX 3522 E page 5

2. Security
 To avoid an electric shock you have to disconnect the UPS from the mains

before connection of the computer to the UPS.

 In case of works on the UPS you have to secure that the UPS is in OFF-modus

and disconnected from mains. The I/O switch at the back of the UPS has to be in
OFF-position. After that you can open the UPS and disconnect the batteries.

 Don’t put the batteries into fire – they could explode.
 Don’t open the battery-blocks. The acid inside these blocks injures skin and

eyes.

 Even a multicellular battery can lead to an electrical shock. Therefore don’t touch

both poles at the same time. Before works at the battery you have to secure, that
there are no metallic things such as rings, bracelets etc. at your arms and hands
which could lead to a short circuit at the poles of the battery. A short circuit on
the battery can produce a very high short circuit current which leads usually to
bad burns and the UPS will ignite.

 Don’t connect the mains input with the mains output of the UPS. The UPS could

be damaged.

 Attention!
Improper handling of the UPS implies a higher risk of electrical shock. Even after

disconnection of the UPS from the mains there may be voltage at the output!
 Attention!
Only authorised persons are allowed to open the UPS. Don’t remove the covering of

the UPS. Avoid the danger of an electrical shock.
There is no component part within the UPS which has to be replaced by the user.

 Warning!
To avoid fire please use only the integrated original fuses!
 Warning!
To reduce the risk of fire or electrical shock the UPS shouldn’t placed in areas with

to high temperatures or humidity. It’s recommendable to install the UPS insides of
air-conditioned rooms.