Wyott SG-20 User Manual

R

SG-30PX & SG-50PX

ASSEMBLY & CLEANING INSTRUCTIONS

1. ASSEMBLY:
Place Sneeze Guard on HR unit as shown. Note that open end of Sneeze Guard base locates
towards front (controls) side of HR unit. THIS IS VERY IMPORTANT ON SLANTED HOT RODS. IF

PLACED OPPOSITE AS SHOWN THE SNEEZE GUARD WILL SLIDE OFF UNIT.

2. CLEANING:
Rinse cover with lukewarm water, wash gently with mild soap or detergent and lukewarm water,

using a soft cloth or sponge. Do not scrub or use brushes or squeegees, rinse again, dry with soft
cloth or cellulose sponge to prevent water spotting. DO NOT USE ALKALIS, HYDROCARBONS,

AMINES, ESTERS, PAINT THINNERS, GASOLINE OR ABRASIVE CLEANSERS ON LEXON
COVER. DAMAGE WILL RESULT.

SNEEZE GUARD

OPEN END

OF SNEEZE

GUARD BASE.

HOT ROD

P/N 300600-95 11/06

APW WYOTT Foodservice Equipment Company

P.O. Box 1829

Cheyenne, WY 82003
[phone] Phone [phone] Toll Free
[phone] Fax www.apwwyott.com