Wyott DTSE Installation Manual

R

INSTALLATION AND OPERATING INSTRUCTIONS

PUMP

Model: DTSE and LTSE

Please complete this information and retain this manual for the life of the equipment. For
WarrantyServiceand/or Parts,this information isrequired.

ModelNumber SerialNumber DatePurchased

WARNING:

damage, injury or death. Read and understand these instructions thoroughly before

!

positioning,installing, maintaining orservicing thisequipment.

[phone] Phone [phone] TollFree
[phone] Fax www.apwwyott.com

Improper installation, operation, service or maintenance can cause property

!

P/N 88751-50 9/05

APW WYOTT Foodservice Equipment Company

P.O. Box 1829

Cheyenne, WY 82003

1

INSTALLATION

1. Clean the pump thoroughly before using it for the first time, according to the cleaning instructions
below.

2.

3. For the LTSE lever action pump, mount the lever to the lid, and then place that assembly onto the

4.

To install the lid, hold the pump upright, unscrew the two retaining nuts, and remove the piston rod
andspout fromthe lowerhalf ofthe pump.

lower half of the pump and hand-tighten the piston retaining nut. Replace the spout and hand-
tighten the spout retaining nut. (Make certain you replace the stainless steel ball, O-ring and piston
seal.)

For the DTSE direct action pump, place the lid on the lower half of the pump, and replace the spout
(ensuring the O-ring and ball are in place), and hand-tighten the retaining nut. Replace the piston
rodand handtighten theretaining nut. (Makecertain youreplace the pistonseal.)

OPERATION

To operate the pump, press the knob or lever down until it stops, then release it. A brisk, smooth stroke
deliversthe condimentuniformly.

CLEANING

NOTE:

If the pumpis usedwith aheated container, allowit tocool beforedisassembling orcleaning it.

Cleanthe pumpdaily.Notethe wayit comesapartso youcan reassembleit Inreverse order.

1. While holding the pump upright, unscrew the spout retaining nut and remove the spout, ball and O-
ring.

2. Unscrew the piston retaining nut and remove the piston rod, piston seal, spring and ball. (For the
lTSEmodel, thelid ispart ofthis assembly.)

3. Clean all parts thoroughly in a detergent solution and then a sanitizing solution, using the brushes
provided.

4.

5. Reassembleusing reverseprocedure.

Rinsethe partsin hot waterand allowthem toair dry.

2