W Y D Technology YD 5010 User Manual

Remote Control Bark Stopper

Effective Bark Control with Remote Control and Night Light

For Battery Operation open back cover and install four 9 volt batteries. BE SURE to align the
+ terminal on the batteries with the + terminal markings in the case. Battery damage will result if
not installed properly.

For continuous powered operation plug the supplied 9VDC 0.35ADC power supply into
bottom jack.

For wide area detection use without megaphone. For narrow area detection attach the
provided megaphone by inserting and rotating slightly until it latches in place.

Suggested normal mounting is 2 to 5 feet above the ground. For detecting a barking dog over
a fence mount Bark Stopper as high as necessary to “look” over the fence. The megaphone is
often used in this case.

The built in Night Light can be manually turned ON or OFF, or it can be configured to turn on
automatically when ambient light is low.

Plug in 9VDC Power Supply for Continuous Operation

If using batteries, when the RED light begins blinking rapidly, indicating low charge, change all
four of the batteries.

Access the configuration panel by removing the front screw and cover. When finished
configuring replace cover and tighten screw to maintain the water tight seal.
Normally select AUDIBLE BLAST for best results. If sound is objectionable to humans, try
ULTRASONIC BLAST. Ultrasonic is usually not heard by humans.

The Dog Stop Ultra will not send a BLAST of energy until it detects a particular number of barks
in a row. You can adjust how may barks are required to trigger, or you can turn off the bark
detection completely. The remote control will still generate a BLAST.

For detecting a bark at a long distance, set the SENSITIVITY adjustment more Right (quiet).

REMOTE MANUAL

OUTLINE

YD-5010 Remote has 3 buttons(ON/ OFF/TEST) and is operated by Alkaline battery 12v
23A.
Remote frequency is 433.92 MHZ and this remote is used to operate YD-5000 Bark Stopper
repeller unit.
Remote Modulation method：ASK