Wunda T02 User Manual

Operating instructions.

1 Open pipe cutters fully by pulling handles
fully apart.

2 Insert pipe into pipe cutter jaws begin
to close pipe cutters by squeezing
handles together, To close the jaws
repeatedly squeeze the handles together
and then release. This will cause the jaws
to close and cut the pipe, fully cut through
the pipe ensuring the end of the pipe is
cut square.

1

✘

✔

Pipe cutters must be used to
ensure a clean cut and square
end to the pipe.

2

1

Pipe Cutter

T02

Pipe Cutter & Reamer User Guide

✆ 0800 083 2677 www.wundatrade.co.uk

...a division of WUNDA GROUP PLC

WUNDATRADE

Operating instructions.

Insert our reamer fully into the end of the
pipe so that the pipe is in contact with the
three cutting teeth.

Push and turn the reamer in a clockwise
direction 2-3 full turns, this will give the end of
the pipe a chamfered finish ready for
connection to the manifold.

A good tip is to grip the pipe wearing a
rubber glove, this will stop the pipe twisting
in your hand.

2

Once cut with cutters, the end of the oor
pipe must be prepared using our reamer
before connecting to the manifold.

Pipe Reamer

T02

Pipe Cutter & Reamer User Guide

✆ 0800 083 2677 www.wundatrade.co.uk

...a division of WUNDA GROUP PLC

WUNDATRADE