W. Silver GS61 Owner's Manual
“Changing
your
life
the touch
of a button”
OWNER’S MANUAL—
with
GS61
Safety Information
Attention! Important safety instructions. Please read
this manual thoroughly before using this product.
Electrical Safety
Always unplug this adjustable bed frame from the electrical outlet before any maintenance or cleaning of the frame. To safely disconnect, make sure all of the controls are
in the o position, and then remove the plug from the outlet. To prevent re or shock
hazard, do not expose this unit to moisture. Keep the power cord away from heated
surfaces. Do not operate this adjustable bed frame and contact the manufacturer for
repair if (1) it is not working properly, (2) it has a damaged cord or plug, (3) it has been
dropped or damaged or (4) has been dropped into water.
Electrical Grounding
This product is equipped with a polarized or grounded electrical power cord. The power
cord will only t into a grounded, electrical surge protection device (not included) or a
grounded electrical outlet. The use of adapters is not recommended unless the outlet is
checked by a qualied electrician to ensure the proper grounding of the adapter.
For optimal safety, your adjustable bed should be plugged into a surge
protector.
Electrical Rating
Input—100-240V, 50/60Hz, 1.6A; Output 29VDC, 2.0A
Battery Precautions
Please follow these precautions when using batteries in this adjustable bed frame:
1. Danger of explosion if the battery is incorrectly replaced. Replace only with the
6LR61 9V batteries and LR03 AAA batteries.
2. Do not mix dierent types of batteries together (Alkaline, Rechargeable and
Carbon-Zinc) or old batteries with new batteries.
3. Be sure to follow the correct polarity when installing new batteries as indicated
in the battery compartment.
4. If the adjustable bed is not going to be used for a long period of time,
remove the batteries from the battery compartment to prevent damage or
injury from possible battery leakage.
5. Do not attempt to recharge a battery that is not intended to be recharged. This
may result in an overheating of the battery or rupture that could result in
injury.
In Home Use & Hospital Disclaimer
Your adjustable bed frame is strictly designed for in-home use only. It is NOT designed
for hospital use and is NOT designed to meet hospital standards. Do not use this bed with
TENT TYPE oxygen therapy equipment or near explosive gases.
Lubrication and Cleaning
Your adjustable bed is designed to be maintenance free. The lift motors are permanently
sealed and lubricated, no additional lubrication is required. Do not apply any lubricant to
lift motor lead screws or any nylon nuts or the base may inadvertently creep downward
from the elevated position.
Warranty Warning
Please do not open any control box, motors or hand controls (with the exception of the
battery compartment, if equipped). The product warranty may be void if any of these
components are tampered with. Do not attempt to alter component wiring or adjust or
modify the structure of the product in any way or the warranty will be void. Only WSP
can authorize any repairs or replacement of parts on your adjustable bed.
Pets and Small Children Warning
Immediately dispose of all packing materials as it may pose a smothering risk to small
children and pets To avoid injury, it is not advised to allow children and small pets to
play on or under the bed. Children should not operate your adjustable bed without adult
supervision.
Consumers with Pacemakers
Your adjustable bed may be equipped with a massage motor that produces a vibrating
motion. It is possible that some pacemakers may interpret this type of motion as a false
sense of movement and/or exercise. This may or may not aect your pacemaker. If you
have any concerns, please consult your physician.
Your adjustable bed also contains Neodymium (magnets) which may interfere with
devices such as pacemakers, ICD’s and any other device sensitive to magnetic elds. It
is strongly recommended that owners of such medical devices consult their physician
prior to using this product.
Product Ratings
The lift motors in your adjustable bed are NOT designed for continuous use. Reliable
operation and full life expectancy will be attained as long as the lift motors do not
operate more than 2 minutes over an 18 minute period, or approximately 10% duty
cycle. To ensure reliable functionality and full life of your adjustable bed, do not attempt
to exceed these limits. Attempting to circumvent or exceed this rating will shorten
the life expectancy of your adjustable bed and may void the warranty.
Acoustics
Your adjustable bed may contain the optional massage motor. This massage function will
emit a noticeable tone during operation. As the massage intensity level is increased, the
volume of the tone will increase. The volume of the tone is directly related to the location
of your adjustable bed. As an example, the surrounding environmental noise that might
have been present in the showroom where you purchased your adjustable bed could have
covered some of the noise from your adjustable bed massage motors. When your adjustable bed was installed in your home you might notice an increase in volume in wood oo-
rings or carpets. In some normal base operations, you might notice some noise coming
from the wheels which allow your adjustable bed to maintain its distance from the wall.
These wheels will make contact with the steel platform supports of your adjustable bed
creating a contact noise when you enter, exit or shift weight while on the bed. This is
normal.
FCC Compliance
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference; (2) This device must accept any interference received, including
interference that may cause undesired operation. To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any
change to the antenna or the device could result in the device exceeding the RF exposure
requirement and void user’s authority to operate the device.
Radio Frequency is 2.4-2.48 GHz
Weight Restrictions
The structure of your adjustable bed will support the recommended weight when distri-
buted evenly across the bed. The adjustable bed is not designed to support or lift this
amount in the head or foot sections alone. You should enter and exit your adjustable bed
with the base in the at (horizontal) position. DO NOT STAND ON THE BASE AT
ANY TIME. The recommended weight limits are Twin/TwinXL/ Split Queen/Split Cal
King: 450lbs., Full/FullXL: 500 lbs., and Queen 600 lbs. Exceeding this weight restriction could damage the bed and/or cause injury and will void the warranty.
Moving After Installation
Do not place adjustable bed base vertically on its head or foot sections. This may cause
injury to persons or damage to the base.
Fabric Cleaning Information
Spot clean only with a water based shampoo or a foam upholstery cleaner. Pretest a small,
inconspicuous area before proceeding. Do not over wet or use solvents to spot clean. Hot
water extraction or steam cleaning is not a recommended cleaning method. To prevent
overall soiling, frequent vacuuming or light brushing with a non-metallic sti bristle brush
to remove dust or grime is recommended.
PLEASE SAVE THIS MANUAL!
Contents
Safety Information 1
Weight Restrictions 1
Cleaning 1
Parts List 3
Base Assembly 4
Location of Controls on Remote 7
Resetting the Adjustable Bed Electronics 7
Troubleshooting 8
Page 2
Warranty 9
Warranty Registration Form 10
User Information
Please take a moment and write down the serial number
in the space provided below, in case you need to refer to it
in the future. This information can be found on the side of
the power supply, on the underside of the adjustable base,
on the outside of the box on the main label and on the
warranty registration card.
Model # GS61
Serial Number:
Customer Care
Toll Free 888-846-3840
Email: customersupport@wsilvermx.c om
Page 3
Parts List
NOTE: BEFORE DISCARDING ANY PACKING
MATERIALS, CHECK THE CARDBOARD BOX
OF THE ADJUSTABLE BED AND VERIFY THE
FOLLOWING ITEMS ARE INCLUDED.
Remote Control
with AAA Batteries (1)
ALL ELECTRONICS AND COMPONENTS THAT
NEED TO BE INSTALLED ARE LOCATED IN
BOXES UNDER THE BASE OR ATTACHED TO
THE ADJUSTABLE BED FRAME.
Power Supply (1)
Connecting strap (1)
(only available on
Twin XL)
Mattress Retainer Brackets Kit (1)
8” Legs (Qty. 4)
Note: the 8” legs are
(2) 4” legs combined.
If you prefer a low
profile bed you may
remove the 4” top section.
Tools
needed
When using your
own headboard:
Plain screwdriver
and a 1/4” wrench
Loading...