Caution : You should read this before proceeding
Please look in chair base for hardware pack.
CHAIR
Label Picture Description QTY
A Chair Seat 1
Page 1 OF 5
B Chair Base 1
Label Picture Description QTY
①
Flat Washers
(φ6mm)
5
②
Spring Washers
(φ6mm)
5
③
Screws
(M6x20mm)
5
④
Allen Key 1
Before
Beginning
Assembly:
Page 2 OF 5
This Chair has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Chair parts, the above picture is
to help you put the various parts into perspective. Please read through the
instructions here below to familiarise yourself with the parts and steps
before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Page 3 OF 5
Step 2
Place the Chair Seat (A) with its bottom side facing upwards onto a clean,
soft surface to avoid any scratches or damage to the product.
Align the Mounting Position of the Chair Seat (A) into the Mounting
Position of the Chair Base (B) as shown above.
Then, affix the Chair Seat (A) to the Chair Base (B) by using Flat
Washers(①),Spring Washers(②),Screws (③) and the Allen Key (④).
DO NOT FULLY TIGHTEN THE SCREWS AT THIS TIME.
Step 3
Page 4 OF 5
Turn the Chair up.Place the Chair on a LEVEL SURFACE.Inspect it and make sure
all parts are adequately connected.Gently and carefully, sit in the Chair.This will help
align all the parts at all the joint areas.
Then get off the Chair, and in a sequential manner, proceed to tighten all
screws.Please turn around each screw 6 times, so they are not too loose nor too
tight.To tighten
the Screws, do secure assistance from your adult partner(s).
You may be required to turn the Chair, to gain easy access to the secure points.Turn
the Chair in a synchronised manner.
CAUTION 1: When tightening these screws, tighten sequentially.
DO NOT tighten any screw fully and then move towards the next one.
This would cause the frame to warp.If the chair wobbles after tightening, loosen the
screws and execute this same process.WARNING!! IF the Chair IS NOT STABLE , IT
COULD LEAD TO DAMAGING THE PRODUCT.Ensure all screws are fully locked
into position.The Chair is ready to be used.
Caution 2: This Chair can only be used on a flat, level surface.
Care & Maintenance
Page 5 OF 5
Loading...