Page 1
Label Picture Description QTY
A Table Top Support 1
B Leg 3
C Fixed Ring 1
D Glass Top 1
Assembly Instructions
Caution : Please read carefully before you proceed
TABLE
Part List
Page 1 OF 6
Page 2
Label Picture Description QTY
①
Bolt
(M6*15mm)
7
②
Allen Key
(M6)
1
③
Washer
(M6)
7
Hardware
Assembly Preparation
Before
Beginning
Assembly:
Page 2 OF 6
Page 3
Overview
Assembly Steps
This Table has multiple parts and may require up to 30 minutes to assemble. To
give you an overview of the Table parts, the above picture is provided to help put
the various parts into perspective. Please read through the instructions below to
familiarise yourself with the parts and steps before assembling.
Step 1
Unpack and place all parts on a clean, non-marring surface.
A)
Glass D)
B)
Fixed ring C)
FRONT FACING
Page 3 OF 6
Page 4
Step 3
Step 2
Place the Table Top Support (A) on the clean, non-marring surface.
Using the Allen Key (②) attach one of the Legs (B) to Table Top Support (A) with
Bolts (①) & Washer (③).
DO NOT FULLY TIGHTEN THE BOLTS.
Repeat the step with the remaining 2 Legs.
Place the Tabel Top Support (A) face down upon the non-marring surface.
Place the Fixed Ring (C) as shown above.
Using the Allen Key (②) attach the Fixed Ring (C) to Leg (B) using Bolts (①) &
Washer (③).
DO NOT FULLY TIGHTEN THE BOLTS.
Repeat the step with remaining 2 Legs.
2
A
B
A
B
3
1
A
B
C
B
C
3
1
2
Page 4 OF 6
Page 5
Step 4
Place the table frame on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Table some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the table frame freely and vertically with the four legs, hitting the ground, at
the same time.
This Drop Test will help to ensure that all the Bolts and gaps all reach full
alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, proceed to tighten all the Bolts.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute the same drop test.
It is important to ensure the table is stable. If it is not stable it could lead to
damage.
Page 5 OF 6
Page 6
Your Table is ready for use.
This Table can only be used on a flat and level surface.
Step 6
Step 5
Take off the glass and level it before putting it on.
Place Glass Top (D) on the top of the table.
D
Page 6 OF 6
Loading...