WowWee Group 0820N User Manual

USER MANUAL

ASSORTMENT NO.: 0820

ITEM NO.: 0821 / 0825

INTRODUCTION BATTERY INFORMATION

Thank you for purchasing MiP™ by WowWee™!

Meet MiP™, your new gesture tracking, self-balancing robotic companion! Out the box, MiP™
is packed with features and personality. MiP™ loves to follow your hand around and balance
things on its tray accessory. Take control, interact and play with MiP™ through Gesture Sense™
technology or a Bluetooth

Take a few minutes to look through this user manual and get MiP™ working.

NOTE: When using MiP™, adult supervision is required, especially when changing the batteries.

Please note the following when operating MiP™:

• Do not immerse MiP™ or any parts in water or any other form of liquid.

• Do not drop, throw, or kick MiP™ as this may damage mechanical functions.

®

1 x MiP™

Low Energy (BLE) enabled mobile device.

1 x Tray

1 x Display Stand

• 1 x Tray Sticker Sheet

• 1 x User Manual

Installing or changing batteries in MiP™:

1. To change the batteries, carefully lay MiP™ on its front. Do not place MiP™ where it could
easily fall. MiP™ requires 4 x “AAA” size alkaline batteries (not included).

2. Using a Phillips screwdriver (not included) remove the screws on the battery compartment
cover located on the back of the robot.

3. Insert the batteries according to the diagram. Ensure that the positive and negative polarities
match the illustrations inside the battery compartment.

4. Replace the battery compartment cover and tighten screws using the screwdriver. Do not
over-tighten.

IMPORTANT BATTERY INFORMATION:

• Use only fresh batteries of the required size and
recommended type.

• Do not mix old and new batteries, different types
of batteries [standard (Carbon-Zinc), Alkaline
or rechargeable] or rechargeable batteries of
different capacities.

• Remove rechargeable batteries from the toy
before recharging them.

• Rechargeable batteries are only to be charged
under adult supervision.

• Please respect the correct polarity, (+) and (-).

• Do not try to recharge non-rechargeable batteries.

• Do not throw batteries into re.

• Replace all batteries of the same type/brand at

the same time.

• The supply terminals are not to be short-circuited.

• Remove exhausted batteries from the toy.

• Batteries should be replaced by adults.

• Remove batteries if the toy is not going to be played with for some time.

MiP™ Battery Diagram/Installation

LOW BATTERY INDICATORS:

When the batteries grow weak, MiP™ will move very slowly and easily fall down while moving
or turning. When this occurs, power OFF and replace all batteries.

• Do not allow the robot to roam freely or leave unattended near edges from which MiP™
could fall.

NOTE: You will know when MiP™’s batteries are nearly depleted because it will make a low
battery indication sound and then power off. You can also see current battery levels via the
MiP™ App.

1 2

MiP™ OVERVIEW

FRONT

MiP™ OVERVIEW

BACk

Microphone

IR Sensor

IR Transmitters

Poseable Arms

Tray Slot (For
inserting tray)

Wheels

LED Eyes

LED Mode
Indicator

Battery
Compartment

Power Switch

Speaker

Stand Slot

Stand

3 4