Worldwel LONGRUN 1500WG Operation Manual

ARC AIR GOUGING

1500WG

OPERATION MANUAL

DO NOT INSTALL, OPERATE OR MAINTAIN THIS MACHINE WITHOUT READING THIS MANUAL

AND PLEASE ALWAYS THINK BEFORE YOU ACT.

www.worldwel.com

■ TECHNICAL SPECIFICATIONS

- Suitable to use for reforming of CO2 Arc welding

- Various uses by different formation like hole expansion, cutting, grooving

- Verify output current during gouging by ammeter on front panel

ITEM UNIT 1500WG

Rated Input Voltage V 380V, 3-Phase, 50/60Hz

Input Current @ rated output KVA 120

Rated Output Current A 1500

Output Voltage @ rated output V 52

No Load Voltage V 92

Duty Cycle @ rated output % 80

Dimension (W×D×H) mm 710X1010X1290

General Safe Practices

■

Wear approved safety glasses with side shields under your welding helmet or face shield and at all
times in the work area.

■

When working above floor level, use a safety belt to protect yourself from a fall should you get a
shock.

■ Do not install or place machine on or over combustible surfaces.

■

Be sure that all installation, operation, maintenance and repair procedures are performed only by
qualified persons.

Electric shock can kill.

■

Wear Dry, hole-free insulating gloves and body protection. Do not touch electrode with bare hand. Do
not wear wet or damaged gloves.

■ Do not touch live electrical parts.

■ Never dip the electrode in water for cooling.

■ Properly install and ground all equipment.

■

Protect yourself from electric shock by insulating yourself from work and ground. Use non-flammable,
dry insulating material if possible, or use dry rubber mats, dry wood or plywood, or other dry insulating
material big enough to cover your full area of contact with the work or ground, and watch for fire.

■ Turn off input power using the disconnect switch at the fuse box before working on the equipment.

■

Frequently inspect input power cable for damage or bare wiring and repair or replace cable
immediately if damaged.