World Tech Toys 35939 User Manual

1: Parental Guidance is suggested for children operating Helicopter.
2: Multiple Helicopters operating simultaneously must be on different Frequency Bands.

• Be sure that Helicopter Battery is fully charged and Remote Control Batteries are fresh.

• Helicopter will fly best in low wind conditions.

• Fly Helicopter in a wide open area with no people, pets, and other objects in the way.

• Do not fly in strong winds. This will make operation difficult and crash the Helicopter.

UP DOWN

FORWARD BACKWARD

ROTATE LEFT

If the Helicopter is rotating
on its own, slowly adjust
the Trim Control Knob

Switch between
High Speed & Low Speed
Modes

Switch LED
Light Modes

ROTATE RIGHT

HERCULES

NANO

3.5 Channel IR Helicopter

ITEM NO. 35939

• Unscrew cover and install 6x AA Batteries as shown.

• Please note polarity and orientation of batteries.

REMOTE CONTROL TRANSMITTER HELICOPTER TAKEOFF ADJUSTMENTS

FLIGHT CONTROLS

CHARGING

TROUBLESHOOTING

PREFLIGHT CONDITIONS

BATTERY INSTALLATION

1: Place Helicopter on a flat surface. Turn on the Transmitter and the Helicopter
2: Check surroundings to be sure that it is clear of people, animals, and obstructions.
3: Slowly push the Throttle Stick up to increase blade speed for lift.

4: Adjust throttle input to maintain a steady hover.

The Left and Right Sticks will move the helicopter as follows:

1: Helicopter can be charged from: USB, Controller,
or AC Charger

2: Move the Helicopter Power Switch to the OFF position

3: Connect Charging Adapter to Helicopter Charge Port.
4: Once charging is complete, disconnect Charging Plug
from Helicopter.
5: Helicopter is ready for flight.

USB CONTROLLER AC CHARGER

The Transmitter
indicator LED
does not work

No control
of the helicopter

Helicopter is
not flying high
enough

Batteries installed with the wrong polarity.

Point Transmitter at Helicopter or operate in conditions
with less sunlight.

Helicopter is not IR receiving signal from
transmitter.

Test the control functions of the helicopter in a
hover by applying light throttle and testing left and
right controls.

Helicopter is not receiving signal from
transmitter correctly.

Push Left Control Stick up for more rotor speed.Rotor speed is too slow.

Fully charge helicopter before use.Batteries are drained.

Fly helicopter in calm conditions. Windy Conditions.

Check the polarity of the batteries and install them
Correctly.

Batteries are drained. Install new batteries.

AGES 8+

1. Power Indicator LED

2. Power Switch

3. Throttle Control Stick

4. Channel Selector

5. Rudder Control Stick

6. Trim Adjustment Knob

7. Infrared Emitter

8. Throttle Speed Regulator

9. LED Light Control

Website: www.worldtechtoys.com
Email: [e-mail]
Phone: [phone]
Monday - Friday / 9:00AM - 5:00PM / Pacific Time

WWW.WORLDTECHTOYS.COM

MADE IN CHINA

SPECIFICATIONS, COLORS AND CONTENT MAY VARY FROM ILLUSTRATIONS

ATTENTION

READ THESE INSTRUCTIONS BEFORE OPERATING THE HELICOPTER

- Install only new batteries of the same type in
your product.

- Failure to insert batteries in the correct polarity,
as indicated in the battery compartment, may
shorten the life of the batteries or cause
batteries to leak.

- Do not mix old and new batteries.

- Do not mix Alkaline, Standard (Carbon-Zinc) or
Rechargeable (Nickel Cadmium) or (Nickel Metal
Hydride) batteries.

- Do not dispose of batteries in fire.

- Batteries should be recycled or disposed of as
per state and local guidelines.

BATTERY CHARGING INDICATORS:

RED light on USB charger will turn on when
plugged in and is not charging the helicopter.
Red light will turn off when the helicopter
battery is charging.

When charging from the remote, the
power/charge indicator LED light will turn yellow
when charging. The light will turn RED when
the helicopter is fully charged.

USB CHARGER

POWER SWITCH

CHARGING PORT