QUICK START GUIDE
CHARGING EVERYTHING
This guide explains the basic functions and settings when using your Recon. Keep
this reference near when piloting the drone and taking pictures and videos. For full
detailed instructions refer to the Recon 4K Follow Me Live Feed Drone User Manual.
Everything is rechargeable! Charge the drones battery using the balance charger and
any standard wall outlet. Charge the transmitter and smart watch via the micro USB
cable and a USB power source. The camera remains charged through the drones
battery pack, you can also use on its own with the included removable battery pack.
When finished, power off Recon battery, transmitter/smart watch & camera to save battery life.
PREPARING FOR FLIGHT
Follow the steps below to get Recon ready to fly and pair with either the Transmitter
or Smart Watch to Recon. You can not pair both devices for the same flight!
Doing so may result in the drone malfunctioning and possibly crashing.
Smart Watch - 1 hour Transmitter - 6 hours Camera - 2 hours
Drone Battery - 2 hours
1. Place the drone on a flat stable surface and turn on the drone by pressing & holding
the power button on the battery pack. The drone will immediately start the flight
system check and gimbal system check when the front red LEDs turn on and the
rear blue LEDs quickly flash.
2. When the rear blue LEDs slowly blink and the drone makes a beep sound, this
indicates that the flight system check is complete.
3. When the gimbal is level, facing down, and the drone makes a second beep sound,
this indicates that the gimbal is ready.
Pairing Transmitter
4. Turn on the transmitter by pushing up the power switch. In a few seconds the
transmitter will connect to Recon when the screen enters the control interface.
5. Wait until the drone gets a GPS signal strength of at least 6 and the screen displays
a icon before take-off. Activate rotors and you are ready to fly.
Pairing Smart Watch
4. Turn on the smart watch by holding the power button. In a few seconds the watch
will connect to the drone when the screen enters the control interface.
5. Wait until the drone gets a GPS signal strength of least 10 and the screen displays
a icon before take-off. Activate rotors and you are ready to fly.
Running Times:
Drone Battery - 25 Min.
Transmitter - 24 hours
Smart Watch - 1 hour
Camera - 70-90 Min.