Workrite Willow Arm iPad Holder User Manual

WillowTM iPad Holder Installation Instructions

Important Safety Instructions

Use only a slightly damp cloth to clean the Willow Arm surface. Never use ammable solvents like alcohol, benzene,
thinner, etc. on the product.

Parts

Willow-Poise Arm

A

iPad Holder
Qty: 1

Attach iPad Holder to Monitor Arm

1

Insert 4 screws (B) through the iPad Holder (A) and the

75 mm VESA plate of the Willow arm, securing each

screw with a Washer Nut (C).

Only gen 2
and 3 iPads
work with this
product.

#10 x 32 x ½

B

Phillips Screws
Qty: 4

#10 x 32

C

Keps Nuts
Qty: 4

A

B

C

Attach iPad

2

Place the iPad into the bottom corners of

a

the iPad holder.

Push the top corners of the iPad until it

b

snaps into place.

Adjust monitor arm balance

3

Once installation is complete it may be necessary to adjust the balance of the monitor arm. See

the instructions supplied with the monitor arm for directions.

To Detach iPad

4

To remove your iPad from the holder, use both hands and press rmly on the right and left top

corners of the holder to un-snap your iPad.

Make sure the
iPad is fully
secured to
avoid dropping
the iPad.

b

#1500188 - Rev A

a