Page 1
User Guide, Revo Platform UB2100FT25
UB2100FT25
Note: Mount your adjustable keyboard arm to your worksurface and your platform to the arm using the instructions
that came with your hardware. Step 1 and Step 2 may have been performed during installation.
Route Keyboard and Mouse Cords on Keyboard Platform
1
Place keyboard cord under
a
overhang at either end of Optimizer.
Place mouse cord under overhang
closest to the mouse.
Route the mouse cord into the slot
b
at back rear corner of the Optimizer.
Be sure to leave enough slack
in cord to allow for unrestricted
movement of the mouse.
2
Attach Cord Clips, Route Cords on Arm and Under Worksurface
Note: Make sure your keyboard arm is fully extended
before routing your cables.
Place one Cord Clip from your keyboard platform
hardware kit on the side of the arm mechanism. Place the
other Cord Clip on the rear of the track. Do the opposite
side in the same fashion if cords run down the le side.
Cord Clip from Keyboard
Platform hardware kit.
Caution: Keyboard Clip adhesion
is designed to bond immediately.
You will not be able to reposition
the clip once it's in place.
Optimizer
Overhang
a
E
Cables will be out
of the way when
platform is in use
Under Worksurface
b
Arm fully extended
E
3
Document Holder
The Revo Platform feature a convenient document holder. Just insert
your document into the slot in the Optimizer.
1 of 2 Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
Optimizer
Page 2
UB2100FT25
4
Changing Mouse Platform Positions
The Revo Platform ships in the In-Line Mouse position. To move the Mouse Platform into a Mouse Over position,
do the following:
With Mouse Platform attached to Keyboard Platform, rotate the mouse platform upside down.
a
Remove the Mouse Platform by pulling out from Keyboard Platform.
b
Flip right side up and reinsert into Keyboard Platform.
c
Swivel over Keyboard platform. You can now mouse over the 10 key if you rarely use those keys.
d
b
In-Line Position Mouse-Over Position
5
Right to Le Handed
a
c
d
Revo Platforms are preconfigured for right handed use but can
easily be converted to le handed use without the need for tools.
Remove the Mouse Platform by pulling it out from the keyboard
platform. Re-inset in receptacle on le hand side.
Reposition Mouse Platform in a comfortable mousing position.
6
Consult the User Guide for your Pinnacle Arm
Go to www.workriteergo.com/instructions to find
the Pinnacle Arm User Guide for instructions on
how to set up this product for ideal ergonomic
benefit.
Document Holder
Consult the Pinnacle
Arm User Guide for
complete instructions
2 of 2 Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
1500290 Rev A
Loading...