Workrite Support Channels User Manual

Parts by Carton

Assembly Instructions
for Support Channels

Support Channel

A

(length differs for each model)
Qty: 1 or 2

B

Verify that you have all the hardware and tools needed for the assembly

You will also need:

or

#3 tip Phillips screwdriver or drill bit

Attach Support Channel

1

#12 x ¾” Screws

Qty: 24 or 48

If you have only one Support Channel, position it on the longer side of the worksurface,

a

approximately 4 inches from the back edge.

If you have two Support Channels, similarly position
the second one on the shorter (or other equal) side
of the worksurface, approximately 4 inches from the
back edge.

If the Channel is being attached to the
side that contains the workcenter’s
control box, be sure to attach the

control box rst, as close to the back

edge of the worksurface as possible,
to allow room for the Channel.

Be sure all cables between legs are within Channel

b

and are not trapped under Channel edge, then
attach Channels using screws provided.

#1500127 - Rev B Workrite Ergonomics | 800.959.9675 www.workriteergo.com