SierraTM Modesty Panel
Assembly Instructions
#1500176 - Rev A
SierraTM Modesty Panel - Assembly Instructions
List of Parts, grouped by package
Rolled Up Modesty Panel
with 2 Aluminum Tubes
Qty: 1
Verify that you have all the hardware and tools needed for the assembly
1
Check your packages against the list above to verify that you have all the parts needed.
You will also need the following tools:
#2 tip Phillips screwdriver or drill bit
#3 tip Phillips screwdriver or drill bit
#8 x .75 Phillips head
B
Screws
For Laminate Tops only
Qty: 6
#10-24 x .38 Pan head
C
Type 23 Screws
For Silhouette Tops only
Qty: 6
or
D
C-Clip
Qty: 3A
⅛" pilot drill bit
Important Note
If you have a Silhouette Top, you will need the
special Drill Kit for Silhouette Tops. If you use a
regular drill bit, you will damage your worksurface.
To order your Drill Kit, call Customer Service and
ask for part #4400303 (the “Silhouette Drill Kit”).
Important Note
You might need to reposition the control box if it is
in the way of the Modesty Panel assembly! Do this
before proceeding.
Important Note
Raise workcenter to its highest position for ease of
installation.
2 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
SierraTM Modesty Panel - Assembly Instructions
Unroll the Modesty Panel
2
Remove the Aluminum Tubes from inside the cardboard tube containing the rolled up Modesty
Panel, then carefully unroll the panel. DO NOT fold or crease the fabric, this will leave permanent
marks.
Attach C-Clips to Underside of Worksurface
3
Determine where you want to position the Modesty Panel under your worksurface. Any location in
a
front of the legs where it will t is okay.
Using one of the Aluminum Rods, with three C-Clips attached as a guide, mark with a pencil where
b
the holes for the C-Clips should be. They should be evenly spaced along the rod.
Drill pilot holes into the worksurface, then attach the C-Clips using the proper screws for your
c
worksurface type.
D
b
Important Note
If you have a Silhouette Top, you will need the special Drill Kit for Silhouette Tops.
If you use a regular drill bit, you will damage your worksurface. To order your Drill
Kit, call Customer Service and ask for part #4400303 (the “Silhouette Drill Kit”).
c
B
OR
C
Workrite Ergonomics | 800.959.9675 www.workriteergo.com 3
SierraTM Modesty Panel - Assembly Instructions
Assemble Panel and Snap Into Place
4
Insert the Aluminum Tubes into the cloth pockets at the top and bottom of the Modesty Panel.
a
Insert top end of Modesty Panel into C-Clips on the underside of the worksurface.
b
a
A
b
4 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Loading...