WOOJEON and HANDAN AQUACAM User Manual
Table of contents
SAFETY ………………………………………………
BASIC PACKAGE BUNDLE ITEMS
BUTTON DESCRIPTION
CHARGING BATTER
SD CARDS
RECORDING,CAPTURE
SETTING
……………………………………………
1)VIDEO RECORDING
2) PHOTO CAPTURE
3) WI-FI ON/OFF
………………………………………………
1) VIDEO
2) PHOTO
3) WI-FI
4) SET UP
5) INFORMATION
…………………………
……………………………
…………………………
…………
24
26
29
30
31
32
33
TRANSFERRING FILES
HDMI TV OUT
APPLICATION
FIRMWARE UPGRADE
SPECIFICATION
TROUBLE SHOOTING
WARRANTY
CALL CENTER
………………………………………
………………………………………
…………………………………………
…………………………
…………………………
……………………………………
……………………………
……………………………………
Table of contents
36
36
37
39
40
41
42
4 4
•
23
SAFETY
Water
1. Do not use Aqua Cam in water 5M deep or more or for longer than 30 minutes.
2. Avoid using Aqua Cam in hot spring or hot water more than 40’C (104’F)
3. Pour water in a container, immerse Aqua Cam for 5 min or so and clean salt, sand, etc. by shaking Aqua Cam
or pressing the buttons in water.
4. Do not let water or sand enter Aqua Cam when port cover is open. It may cause trouble Aqua Cam. Do not open
or close port cover with wet or sandy hands. Open port cover after drying your hands thoroughly.
5. Do not let foreign materials such as sand, hair, dust, etc. captured in the water-proof packing.
6. Water may leak into Aqua Cam if port cover is not closed tight. The warranty is not applicable to damage caused
by water leakage.
7. Ensure that port cover is closed thoroughly before using Aqua Cam. Water leakage may be caused.
8. Do not open port case while using Aqua Cam waterside.
9. Images taken in water using Aqua Cam may not be clearer than normal images, but it is not a trouble.
10. Aqua Cam does not float in water.
After using Aqua Cam
1. It is recommended to wash Aqua Cam withfresh water within 60 minutes after using it.
2. When contaminated by chemicals (thinner, benzene, alcohol, disposable towel, insect repellent, sunscreen,
insecticide, etc.) including detergent, soap, oil, etc, immediately wipe off with dry cloth.
3. Immediately wash off with clean water after using Aqua Cam in sea water. Corrosion or deformation of the product
may be caused.
4. Even small foreign materials may cause water leakage. Make sure that there is no defect in the water-proof
packing.
5. Do not clean Aqua Cam with a sharp object. Scratch on the waterproof packing and O-ring contact surface may
cause water leakage.
6. Carefully check there is any sand, hair, salt, dust, threads, dirt, etc. on the O-ring. If found, be sure to sipe off
with a soft cloth or tissue paper.
7. Be careful not to leave any cloth or tissue pater fibers on the O-ring after cleaning it
8. Check the O-ring for cracks, skewing, distortion, fine splitting, scratches, embedded sand, etc. Replace
O-ring if you find any of these.
9. Check the O-ring contact surface on Aqua Cam in the same way
SAFETY
•
24
O-ring
1. Aqua Cam port cover uses an O-ring to maintain its waterproof.
2. O-ring maintenance is very important. Failure to do O-ring maintenance may lead to water leaks
3. The serviceable life of the O-ring variens with frequency of use of the port cover and conditions. Generally, it is
about one year.
Storage
1. Do not expose Aqua Cam to direct sunlight or heating instruments. Do not leave it inside a parked vehicle in the
summer season.
2. Do not use the product near fire (Do not put it in an electric oven.)
3. When port cover is open and closed in a cold place like ski ground, snow or water drop got into the operating
parts such as port cover, button, microphone etc. may be frozen, leading to improper operation of Aqua Cam.
4. Do not store or use Aqua Cam in very hot, humid spaces such as sauna room, etc.
5. Do not have behaviors such as dismantling, compression, penetration, etc.
Temperature
1. Aqua Cam temperature rise while using it for a long time.
2. Quality of image may be degraded as Action Cam temperature rises.
3. It is recommended to leave for 10 minutes or longer until Aqua Cam inside temperature to decrease to safe level.
4. The exterior surface of Aqua Cam may get hot but it is not a melfunction.
5. When Aqua Cam temperature reaches 70 ℃, Aqua Cam power automatically turns off for the safety.
6. Battery lifetime may be reduced at temperature range 0~-10 ℃.
Others
1. Aqua Cam design, specification and operation manual are subject to change without prior notice.
2. Figures in the user’s manual may look different from the actual Aqua Cam.
3. Audio and video of Aqua Cam is subject to being affected by electromagnetic radiation at specific frequencies.
4. This wireless equipment may cause radio interference and should not provide any service associated with safety
of human life.
5. Use only the accessories (charger, holder, etc.) from the specified vendors.
6. This product has passed through the drop test at 1.5m above a polywood plate of 5cm in thickness. However,
this does not guarantee damage free, fault free and water proof performance under all situations.
SAFETY
•
25
BASIC PACKAGE BUNDLE ITEMS
➊ Aqua Cam ➌ Handlebar Mount/Adhesive Mount
➌User’s Manual ➍ Warranty Certificate ➎ Charging port cover
품질 보증서
본 제품은 고객 여러분의 더욱 편리한 생활을 위해 품질 관리를 통해 엄격한 검사에 합격한 제품입니다.
다음과 같이 품질을 보증합니다.
품질 및 형식명 Duran Aqua CAMCORDER
제 조 번 호 보 증 기 간 구입일로부터 1년
구 입 일 자 년 월 일 제 조 자 명 (주)우전앤한단
년 월 일 수 리 내 용 수 리 처 확 인
보상기준
제품수리, 교환, 환불에 대한 보상기준은 재정경제원 고시 「소비자 피해 보상 규정」에 따릅니다.
사용설명서
(AQUA CAM)
•본 사용설명서는 제품 기능 향상을 위해 사전 통보없이 변경될 수 있습니다.
www.duran.co.kr
부품 보유기간
수리용 부품 보유기간은 제품단종 후 6년까지입니다.
무상 서비스
제품을 구입하신 날로부터 12개월(무상보증기간)내에 아래와 같은 고장이 발생하였을 경우 본 제품을
구입하신 곳이나 대리점에서 무상으로 수리해 드립니다.(단, 배터리, 액세서리는 6개월 이내입니다.)
•설치시 제품 자체에 문제가 있을 때 •정상적인 사용중에 고장이 발생하였을 때
유상 서비스
사용자의 부주의로 인한 고장에 대해서는 실비의 수리비와 부품비를 받습니다.
서울특별시 금천구 가산동 569-12 | ▒ TEL : 02)2105-0757
BASIC PACKAGE BUNDLE ITEMS
•
26
★ A fixed form
Like the picture above, Aqua cam is tied using Handlebar Mount /
☞
Adhesive Mount at the place where you want to set.
This product is not being used as "Portable device",
☞
instead be used as fixed position.
BASIC PACKAGE BUNDLE ITEMS
•
27
★ Replacing the PORT COVER
Bundle provides a charging port cover for water resistance environment
☞ To be water resistance, you must use ‘Duran USB cable’
☞ You can remove the port cover by laterally inserting a
sharp pin or pen into the micro SD card slot.
Portable port cover
Charging port cover
(Water resistant)
★ Closing the PORT COVER
If the port cover is not closed tight, water leakage may be caused.
1. Insert the projected part marked with arrow into the body (Figure 1,2).
2. Press the upper part to fix the port cover (Figure 3).
(2) (3)(1)
BASIC PACKAGE BUNDLE ITEMS
28
•
BUTTON DESCRIPTION
Recording Start / Stop / Select / Power ON,OFF(Press hold)
Moving cursor / Move to Detail setting menu
(Press hold)
BUTTON DESCRIPTION
•
29
Micro-5Pin
(USB) jack
Reset button
Micro-HDMI out jack
(not inchide)
Micro-SDcard insertion slot
(not inchide)
Loading...