Woodstock D4159 User Manual
Model D4159
#16601TS
220V/240V ON/OFF
Paddle Switch
Instruction Sheet
Phone #: (360) 734-3482 • Online Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz
To reduce risk of serious burns, electrocution or death when installing this switch:
• Only use this switch to replace an existing
machine switch that has the same physical configuration and equivalent electrical specifications/ratings.
• Installation must only be performed by an
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.
Figure 1. D4159 220V/240V ON/OFF Paddle
Switch.
• Turn OFF and completely disconnect all
power sources to the machine before
installing the switch.
• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. It is not sealed or
rated for these environments.
• Make sure there is a verified machine
ground on the circuit this switch is
installed.
Introduction
The Model D4159 features a recessed ON ( — )
button that can be disabled with a padlock, and
a large OFF paddle that ensures fast shut-off.
The switch assembly will mount on a standard
electrical box, or over a 1" x 2" opening.
Specifications
Rated HP ..........................................2 HP
Rated Voltage ............................ 220V/240V
Rated Current ..................................... 16A
Padlock Shaft Size ...............................
3
⁄16"
COPYRIGHT © MAY, 2014 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in China
D4159 220V/240V ON/OFF Paddle Switch
Installation
When installing the D4159 switch, use the wiring
diagram in Figure 2 to ensure proper wire
connections.
This switch is intended to be connected to
stranded wire with insulated quick-disconnect crimp-type female wire terminals hav-
1
ing a
All crimps must be "pull-checked" to ensure
that wires are securely crimped and will
not fall out with moderate tension or when
exposed to normal machine vibration.
⁄4" tab.
Machine
Verified
Ground*
Disabling & Locking Switch
The switch can be disabled and locked by
inserting a padlock through the ON/START
button, as shown. Locking the switch in this
manner can prevent unauthorized operation of
the machine, which is especially important if the
machine is not stored inside an access-restricted
building.
IM PO RTA NT: Locking the switch with a padlock
only restricts its function. It is not a substitute
for disconnecting power from the machine when
adjusting or servicing.
Shaft
ON / START
Button
OFF / STOP
Paddle
Padlock
Hot
Out
KEDU
Hot
Out
KJD17B
IP55
Rear View
14
13
Hot
In
Power Source
24
23
Hot
In
of Switch
Figure 2. D4159 wiring diagram.
*The machine MUST be connected to a verified
ground. In the event of certain malfunctions
or breakdowns, grounding reduces the risk
of electric shock by providing a path of least
resistance for electric current.
Figure 3. Switch disabled by padlock.
Children or untrained people can be
seriously injured by this machine. This
risk increases with unsupervised operation.
To help prevent unsupervised operation,
disable and lock the switch before leaving
machine unattended! Place key in a wellhidden or secure location.
The padlock shaft diameter is important to
the disabling function of the switch. With
any padlock used to lock the switch, test the
switch after installation to ensure that it is
properly disabled.
-2-
Loading...