Woodstock D4028, D4032 User Manual

Model D4028/D4032

8" & 12" Digital Scale

Instruction Sheet

Phone #: (360) 734-3482 • Online Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz

Introduction

Mount the Model D4028/D4032 on woodworking and metalworking machinery for precise relative distance measurements between fixed and moving parts, such as table height, cutter height, tool depth and more.

Specifications

Maximum Measuring Distance (D4028) ..... 8 1⁄2" (216mm)

Maximum Measuring Distance (D4032) ..... 12

Resolution ............................................... 0.01mm

Maximum Measuring Speed ..................... 1500mm/sec

Battery................... One 1.5V AG13 (LR44) Button Cell

Data Port ................................... 2-Conductor Serial

⁄4" (324mm

Identification

Refer to Figure 1 and the following descriptions to better understand the components of the digital scale.

A. Upper Mounting Bracket: Secures the scale body to

a fixed machine part with

B. OFF Button: Turns unit OFF. C. Data Port: Allows a connection to an exterior

device.

D. ON/Zero Button: Turns unit ON and zeros the display

when held.

E. Battery Compartment Cover: Slides to the right for

access to the battery.

F. Display Mounting Bracket: Installs on the back

of the display unit with the two included M3-.5 x 6 Phillips head screws, and mounts to a movable machine part with

G. Lower Mounting Bracket: Works with the upper

mounting bracket to secure the scale body.

H. Scale: Shows the relative distance the display unit

moves in inches (0.10" resolution) and millimeters.

⁄8" fasteners.

⁄8" screws (not included).

Figure 1. Identification (Model D4028

shown).

I. Decreasing Button: When held,

decreases the displayed number for precise adjustments.

J. Increasing Button: Increases the dis-

played number when held.

K. Inch/mm Button: Toggles the display

between inches and millimeters.

L. Digital Display: Displays the current

measurement.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT

THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.

Printed in China#13363TS

Mounting

The digital scale can be mounted to machinery in various ways. The goal is to attach either the display unit or scale body to a fixed machine part and the other component to the movable machine part. This allows you to measure the relative distance the movable machine part travels.

IMPORTANT: Choose the digital scale model that has a scale body longer than the full travel of the parts being measured. This will ensure that the display unit is not damaged as the machine parts move through their full range of motion.

Calibration

When the digital scale is properly attached to the machine, bring the movable machine part to the starting position, then press the ON/Zero button to zero the display. Position the movable machine part a known distance from the starting point, then use the decreasing and increasing buttons to make the display reading agree with the known distance.

D4028/D4032 Digital Scale

NOTICE

The Model D4028/D4032 digital scale is not designed to be used around liquids of any kind. Exposing the display unit to liquids could cause permanent damage to the internal electronics, which will not be covered under warranty.

Battery

If the digital display does not come on or it flashes, the battery voltage is low. Turn the unit OFF, remove the battery compartment cover by sliding it to the right, then replace the battery. Re-install the cover before turning the unit ON.

Troubleshooting

Problem Possible Cause Corrective Action

Flashing digits. Low battery. Replace the battery.

Frozen digits. Internal circuit error. Remove battery, wait

No display. Low battery voltage;

poor contact.

30 seconds, then replace battery.

Replace battery; make sure the battery contacts are clean.

-2-