Woodstock D2483 User Manual

Hot Melt Glue Gun – Small

Manufactured in

China for Woodstock

International, Inc.

Visit our website @

woodstockinternational.com

D2483

SHOP FOX® IS

A REGISTERED

TRADEMARK

OF

1-800-840-8420

FAX: [phone]

HOW TO USE THE GLUE GUN:

1: Plug in gun. Load the glue sticks into the back of the gun.
2: Press trigger several times until the glue stick is firmly set into the inner tube.
3: Allow the glue gun to warm up for approximately 5 minutes.
4: Squeeze trigger until glue flows from the nozzle.
5: Glue need not be spread. Press surfaces together within 15 seconds. Use of clamps or other holding
devices is not necessary. Clean surfaces for best bonding.
6: Unplug glue gun when finished. No clean up required. Never pull the glue stick out the back of the gun.
Use 5⁄16" glue sticks only.
CAUTION: Hot melt glue gets hot! Nozzle area temperature reaches 380°. If accidental contact should occur,

265900961

do not try to remove the glue. Put in cold water immediately.