INSTALLATION MANUAL
R
WOODBRIDGE
SHOWER DOOR
SHOWER DOORS:
MBSDC4876
IMPORTANT!
WOODBRIDGE reserves the right to alter, modify or redesign products at any time without prior
notice for the purpose of product improvement and customer experience. Please refer to
WWW.WOODBRIDGEBATH.COM for the latest product details.
Questions?
Please Call Customer Support: 562-229-0088. (Monday - Friday 9 AM - 5 PM Pacific Time)
Or Email: help.woodbridge@gmail.com
MBSDC6076
www.woodbridgebath.com
TUB DOORS:
MBTDC6062
20200307 REV. 3
1
IMPORTANT
•WoodBridge reserves the right to alter, modify, or redesign products at any time
without prior notice for product improvement or functionality.
•Professional installation required. This product should be installed by someone
experienced with the construction requirements for this type of project, the care
necessary to responsibly and safely install, and familiarity with glass installation.
•The safety of all installations is the responsibility of the installer who should be
licensed and bonded.
•To prevent breakage and injury, do not attempt to lift, move, or install the glass
alone. Use an assist and suction cups intended for heavy glass when applicable.
•To prevent breakage and injury, do not lean or push against glass panels.
•The installation of this model requires drilling into the dam/curb/threshold to
properly affix the clip, guide, and threshold. Contact the manufacturer of your
base, or tub with any questions regarding drilling into their product, or consult your
installation professional.
•This model requires minimum 3" dam/curb/threshold width to complete
installation.
•Drawings included in this manual are illustrative only and do not reflect actual
scale.
•No out of plumb adjustment.
•Glass cannot be installed if the overall width of the shower opening is greater than
the width as described for the product.
WARNING FOR TEMPERED GLASS: TO AVOID RISK OF DAMAGE OR INJURY
•Tempered safety glass is designed that when broken, will shatter into thousands of
tiny pieces, greatly reducing the chance of great bodily harm.
•Follow all requirements and recommendations in the instruction manual.
•Perform a thorough inspection of the glass and hardware for any damage prior to
installation.
•Do not install damaged glass.
•Do not install or operate if glass panels have chipped corners, slivered edges, or
any other visual defect. If damage is found contact WoodBridge immediately. If
installed in this state WoodBridge is not responsible for any breakage.
•Do not install glass panels that have been dropped on, or bumped into any
surface harder than itself.
•Improper handling may cause breakage.
While incredibly resistant to direct impact, corners and edges are the most
susceptible to damage, causing breakage. These edges should be protected and
handled with care, never allowed to come into contact with any material harder
than itself, such as tile, stone, metal, or even other glass. A concentrated point of
impact or contact with such material can cause the glass to shatter. Tempered
glass may release all at once, or partially, releasing hours or even days later with
vibration and normal use.
•Incorrect installation of the hardware, rollers, stoppers, or glass may cause
breakage.
Improper installation would include loose hardware, or lack of gaskets between
hardware and glass. Installing out of level or plumb causing extra stress could
www.woodbridgebath.com
2
•Improper use of the product.
Do not place towels or anything else over guide rail. Aggressively opening or
closing the slider may cause trauma to the glass which could lead to breakage.
•Do not attempt to cut tempered glass.
•Always wear safety equipment such as goggles, work gloves, proper footwear
etc... during installation.
•Instruct homeowner on how to conduct periodic inspections and how to
properly maintain the glass and all hardware.
•Consideration should be given when installing tempered glass products in
households with young children or elderly.
PREPARATION
•Thoroughly read the instructions before installing or using the product.
•After boxes and packages are open, before installation, check that all items
from the parts list are there by marking each one off the list.
•Examine the glass and parts for defects or damage.
•Please note that Woodbridge will not replace any missing or damaged items
free of charge after 5 business days or if the product has been installed.
•Building codes vary by location and you should refer to your local building
codes when installing. WoodBridge is not responsible for code compliance and
will not accept returns on that basis.
•Prior to installation ensure that all surfaces are smooth and even. Ensure the
dam/curb/threshold is level side to side and that it has slope/fall in the direction
of the shower pan. Ensure the walls are plumb and the opening measures the
same top and bottom. Ensure that the installation surface is solid and able to
support the weight of the doors.
•Please note that irregular installation surface, round lower corners, or out of
plumb walls will result in serious problems for your installation.
•Some adjustments and drilling/screwing will be necessary throughout
installation.
•Woodbridge shower doors are not designed to be installed on fiber glass
surrounds that have round lower corners or lack of solid mounting surface.
•Glass must never be set down directly on any hard surface. Always use pieces
of wood or thick cardboard to protect lower edge at all times. Leave corner
protectors in place until it is time to remove them
www.woodbridgebath.com
3
WOODBRIDGE
R
!
E
A
B
D
F
C
B
A
IMPORTANT INFORMATION
REGARDING THE INSTALLATION
OF THIS SHOWER DOOR
A.Guide Rail Brackets must be firmly attached to the wall. Installation into a stud is
strongly recommended. All of the guide rail bracket set screws must be accessible
and tightened.
B.Thread Lock must be applied to the set screws in both stoppers. Door-side stopper
must be installed at the proper position to prevent the door from contacting the wall.
C.Roller Wheel Assembly safety set screws: must be accessible and must be
retightened with Thread Lock during installation.
D.Bulb Vinyl Seal must be installed on the closing edge of the Glass Door from
contacting the wall.
D.The Guide Block must be screwed to the threshold and installed square with the
Stationary Glass and Glass Door. Installing the guide block crooked may damage
the bottom edge of the Glass Door and lead to breakage.
www.woodbridgebath.com
4
WOODBRIDGE
R
R
Tools
Level
Tape
Measure
Pencil
Phillips
Screwdriver
Silicone
WOODBRIDGE
Drill Bit
Ø1/8"
(3mm)
Safety Glasses
Drill Bit
Ø3/16"
(4mm)
Drill Bit
Ø1/4"
(6mm)
Work Gloves
Drill Bit
Ø5/16"
(8mm)
Hacksaw
Drill Bit
Ø3/8"
(10mm)
Soft Head
Hammer
#3 Phillips
Driver Bit
Miter saw
R
Professional-grade
Glass suction cup
Power
Drill
Painter's Tape
WOODBRIDGE
No modifications to the product are allowed. Modifications of any types to the product will result in serious injuries or may cause death.
IMPORTANT: Do not install the handle on to the glass door unl the
instrucon tells you to do so. Never li the glass using the handle. Failure to
do so will result in serious personal injury and could cause damages to the
glass. Professional graded glass sucon cups are highly recommended while
handling extremely heavy glass. This product must be installed on a finished
threshold and against finished walls only. This product is intended for
residenal use only.
INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN SERIOUS INJURY OR DEATH
LICENSED AND INSURED PROFESSIONAL CONTRACTOR IS REQUIRED TO INSTALL
THIS PRODUCT INCLUDING ASSISTANCE OF A SECOND PERSON DURING INSTALLATION
Razor Knife
CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT.
THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION!
Extender Driver Bit
Soft Cloth
or Blanket
Soft Wood
Shim
www.woodbridgebath.com
5
WOODBRIDGE
Parts List
R
1 2
Bumper Strip
4
Upper Guide Rail
7
x1 x2
x1
Guide Rail Brac ket Glass Door Sto pper
5
8
Roller
x2
3
6
9
Handle
x2
x1
Glass Door
10
Screw M4X30
13
Bottom Clamp
16
x1
x2
x1
Side Anti-Water Strip
11
Guide Block
14
Stationary Glass Screw M5X60
17 18
x1
x1
x1
Anti-splash Threshold
12
Wall Anchor
15
x1
x5
x2
Glass Bracket
x2
www.woodbridgebath.com
Safety Pin
x2
2.5mm
2mm
AllenKey
3mm
4mm
5mm
x1
S
et
7
WOODBRIDGE
Model Specific Preparation
No Out-of-Plumb
Adjustment; Verify
threshold and walls
with a level
Threshold must be
level
R
R
±0.0±0.0
±0.0±0.0
3” minimum
threshold
WOODBRIDGE
R
!
Threshold must be level
!
PANEL
DOOR
PANEL
DOOR
WOODBRIDGE
NOTE
This model is reversible for right or left-hand door installation. The right-hand door installation is
shown as an example throughout this manual. For the left-hand door installation, simply begin on the
opposite wall and reverse the orientation of the steps shown.
8
www.woodbridgebath.com
WOODBRIDGE
R
Wall
W
W
90°
W
1.Measure the distance between two finished walls. This distance is marked as W.
Please see Fig 1 for details:
Fig 1
www.woodbridgebath.com
9