Wonders Technology WB60 User Manual

Outdoor Waterproof Bluetooth Speaker

Mode No.: DOSS Traveler
User Manual

Thank you for purchase DOSS Traveler Portable Wireless Bluetooth

Speaker with Bluetooth and Waterproof function. We encourage you to
read this instruction guide thoroughly to get the most out of this
innovative wireless portable speaker.

II. Package content

• Outdoor waterproof speaker x 1

• USB charging cable x 1

• Φ3.5mm auxiliary cable x 1

• Handle belt x 2

• User manual x 1

III. Product overview

1 32 4 5 6

1.

2.Indicator: Different lights indicate different modes.

3.Mode switch: Short press to toggle play mode among Bluetooth,

4. Light mode: Short press to switch four different lights. Low brightness,

Medium brightness, High brightness, SOS(emergency signal).

5. Play/Pause:

•In Bluetooth mode, press to play/pause your tune. Press for 3

seconds to disconnect with your device.

In Bluetooth mode, press to answer or end a call. Press for 3

•
seconds to reject a call.

•In TF mode, press to play/pause your tune.

6. Volume/Track control:

• Short press to decrease the volume.Long press to skip previous song.

• Short press to increase the volume. Long press to skip next song.

Press 3 seconds to turn the device on or off.

Reset

7 8 9 10 11

7. Auxiliary Φ3.5mm jack : Use it for cabled playback with compable

devices.

8. LED charging indicator.

• Charging : Steady Red.

• Fully charged : Steady Green.

9. Charging port: Plug the supplied USB cable into this port to recharge

10. Reset mode: Reset speaker when it can't work.

11. TF card: Use it for TF card (with music) playback.

Status indicators

Indicates that the speaker
has entered into the pairing
mode and it is ready to be

Indicates that the device is
successfully paired

Indicates that the device has
switched to the auxiliary
input mode

Indicates that the device has
switched to the TF mode

Center indicator/

indicator

Flashing blue

Steady blue

Steady red

Steady Green

Steady red

Steady green

Wonders Technology Co.,Ltd
Email:[e-mail]
Follow us on Facebook:

• Use the supplied USB cable to charge your portable speaker directly
from your computer or device with a micro USB port.

• Make sure that the speaker is fully charged before using it for the

•

capacity, the LED will change to green.

3 seconds.

the device.

V. Pairing the wireless speaker with your smart device

1. Place your smart device and wireless speaker no more than one meter

away from each other.

seconds to turn it on.

3. Set your smart device to “discover” the wireless speaker. Upon

powering on, a tone will be heard, the blue LED will start flashing,

the pairing mode.

4. Enabled Bluetooth on your device and choose DOSS CloudFox Sport

from the list.

5. If pairing is successful, the LED will change to steady blue and your

5 described above.

several

VI. Answering and ending a call using your speaker or

mobile phone

1. When there is an incoming call, the speaker will generate a tone and

2.

Briefly press the Handset buon to pick up, long press to reject.
You may also press the answer buon on your phone to take the call

using the speaker.

3. Speak with a clear voice right into the built-in microphone located on

To end a call, tap the Handset buon once again. Likewise, you

4.

may also end the call directly using the command on your cell phone.

5. When listening to music using your smart phone, playback will resume

VII. Features and proble

Waterproof, Shockproof, Dustproof Rated IP67 for 100% protecon

1.

against Water and Dust. Rubberized rugged exterior for ulmate
impact resistance. Water-resistant HD loudspeaker, and splash-proof

surface to increase mobility and usability for everyday indoor or

outdoor use such as shower, beach, pool, boat, bathroom, car, office,

and much more!

2.

Modes: high brightness; medium brightness; low brightness;

SOS (emergency signal)

3.

Quick ps about how to use handle belts:
Undo the two nuts counter-clockwise on the strap.

•

Remove the nuts from the straps, then put the strap through the strap

•

buckle.
Tighten the screw clockwise on the strap.

•

10.6 in

65.0 in

Using it with your Amazon Echo Dot

You can connect the Amazon Echo Dot with the speaker via 3.5mm Aux-in
cable or Bluetooth, here is how to set up laer opon

Download the Amazon Alexa App, follow the standard setup

1.

procedure to get the Echo dot connected to your home Wi-Fi.

Switch the CloudFox speaker to Bluetooth mode,you can press the

2.
‘play/pause’ buon for 3 seconds to keep it in pairing status.

Run the Alexa app, tap ‘Connue’ and Select Bluetooth .3.

The DOSS CloudFox speaker should appear in the list of Bluetooth

4.

devices. If no that, press the ‘play/pause’ buon for 3 seconds and

try again. When it does, tap it to complete the pairing process.

5.Connect Echo Dot to DOSS CloudFox using an Aux-in cable.

Note: Whatever you connect it via Bluetooth or Aux-in cable,your
voice command cannot turn on/off the DOSS CloudFox,that can

only transfer sound signal.

Product type: Outdoor Waterproof Bluetooth Speaker
Output power: 10W x 2

Driver unit: 1.7 inch speaker x 2 + 2.6 inch passive radiator
Frequency response: 65Hz-18kHz

Signal to noise rao: 50dB

Unit weight: 600 g

Unit dimension: 6.50x 4.45 x 2.24 inch
Warranty: One-year limited

VIII. Power

• Input:5V 2A

7.4

IX.Wireless/Networking

Bluetooth versions

• Profiles supported

X. Warning

• Do NOT disassemble, repair or modify the Bluetooth speaker by yourself.

• Do NOT use cleaning products that contain benzene, solvents or alcohol.

• Do NOT place heavy objects on top of the Bluetooth speaker.

• Do NOT use near a microwave oven or wireless LAN products.

Trouble Shoong:

Bluetooth

TF Card

other

Cannot Pair with Bluetooth
devices

Cannot play music aer pairing Please select 'DOSS CloudFox Sport' as

The song cuts off during

playback

There is noise during playback Maybe caused by the interference of

Laptop prompts to install driver This driver is not special for CloudFox

Not paired with transmier

The speaker do not play when

the card is inserted,and jump

directly back to Bluetooth
mode.

The song cuts off during

playback.

All the lights are lit and can not
be turned off

Customer Service Email [e-mail]

Problem

Soluon

Press Play/Pause buon for 3

seconds,then have a try to pair it
again.

the default playback device.

Please check if the Bluetooth distance

is more than 33 feet or the baery

level is low.

charging,try to put it in another place
and do not charge it during playback

Sport,it's for your laptop Bluetooth

funcon, please contact the

computer company or windows

Please press Play/ Pause buon
for 3 seconds or contact with the
transmier' s customer service

for help

Check whether the card format is FAT
or FAT32. If not, format it to FAT or
FAT32.

Check the song format. The speaker

only supports MP3, WAV, WMV.

There may be a problem with the

song's file, try deleng all the songs in
the same file.

Use the needle or wire to poke the

reset buon inside Aux-in

FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.