Wonders Technology SP 58031, DS 1168 User Manual

IMPORTANT SAFETY INSTRUCTIONS
For the safety of you and Bluetooth® speaker, follow the
precautions below:

● Do not expose the unit to liquid, moisture or humidity to avoid the

product's internal circuit being affected.

● Do not use abrasive cleaning solvents to clean the unit.

● Do not expose the unit to extremely high or low temperature as this
will shorten the life of electronic devices, destroy the battery or

distort certain plastic parts.

● Do not dispose of the unit in fire as it will result in an explosion.

● Do not expose the unit to contact with sharp objects as this will
cause scratches and damage.

● Do not let the unit fall down onto the floor. The internal circuit might
get damaged.

● Do not attempt to disassemble the unit as it may get damaged if you

are not professional.

CAUTION: TO PREVENT THE RISK OF ELECTRlC SHOCK.

DO NOT DISASSEMBLE BODY

NO USER-SERVlCEABLE PARTS INSlDE.

FCC statements:

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may

cause undesired operation.

Warning: Modifications not approved by the party responsible for
compliance could void user’s authority to operate the equipment.

NOTE: This product has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful

interference in a residential installation. This product generates, uses

and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If the product does cause

harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the product and receiver.

•Connect the product into an outlet on a circuit different from that to
which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Box contents Product Feature

Charing base

Bluetooth speaker

A B C D E F G J K LH I

A. Microphone
B. Vol-

USB charging cable

C. Handsfree
D. Vol+
E. LED indicator

F. Play/Pause

User manual

USB charging cable

3.5 mm stereo audio cable

G. Switch on/off
H. Aux in jack

I. Charing LED indicator
J. Charging plate

K. Charging mode switch

L. Micro USB port

CHARGING THE SPEAKER

1.Turn the switch to INPUT, then put the speaker on the power station

and connect the USB cable to a computer or a 5V/1A power
adaptor(power adaptor not included in packaging), the LED

indicator flash red and blue, after fully charged, LED will go to off.

If charge speaker by power station only, please switch to OUTPUT,
the LED indicator flash red and green, after fully charged,
LED flash green.

If charge the power station only, switch to INPUT and LED flash
blue, after fully charged, LED will go to off.

2.Using the power station as battery bank, connect USB cable

extender and switch to OUTPUT, LED flash green.

CONNECTION AND USE THE SPEAKER

Bluetooth Pairing

1.Switch on speaker, blue LED display solid blue for seconds then

start flashing, Turn on the Bluetooth device on your phone or tablet,
search“DS-1168 ”and pair. When successfully paired, LED will
display solid blue light. If smart phone need password,

please enter 0000.

2.Adjust the volume by pressing
the Volume +/- buttons on

the top of speaker and on

your bluetooth device. Press
the Play/Pause button to play

or pause the tune. Press and

hold the Play/Pause button to
terminate bluetooth Connection.

3.Handsfree function, when a call coming,

press handsfree button to answer the
phone call. After the call ends, the speaker

will continue playing the interrupted music.

4. Power off, when not in use, please switch

off speaker to save battery.

Audio input using 3.5mm cable

1.Connect a 3.5mm audio cable to the 3.5mm Audio input on the
speaker and on an external audio output such as MP3 players.

2.Speaker will switch to Line-in mode automatically.

3.Press the Vol-/+ button on speaker or native controls on the
connected MP3 player to control volume.

4.Press Play/Pause on the audio player to play/pause the tune.

Using the Bluetooth® microphone
Answering and ending a call using your mobile phone
When there is an incoming call, the speaker will generate a tone
and a verbal notification to alert you of this event.
Briefly press the Hands-free button to pick up. You may also press the

answer button on your cellular phone to take the call using
the speaker.

Speak with a clear voice right into the built-in microphone

located on the front section of the speaker.
To end a call, tap the Hands-free button once again.

Likewise, you may also end the call directly
using the command on your cell phone.
When listening to music using your mobile
phone, playback will resume automatically

once the call has ended.

TECHNICAL SPECIFICATION

Speaker battery: 3.7V 500mA Li-ion battery
Charging base battery: 3.7V 1020mA Li-ion battery

Charing base input: 5V 1A

Speaker size: 2” (5 cm)
Output power (speaker): 1.5W RMS

Net weight: 348 g

TROUBLESHOOTING

Symptom

Cannot pair
successfully

Possible problem

Speaker not power on

or your bluetooth device
paired with other device,
or interference from
other bluetooth device

Solution

Check whether the speaker
is in power on and

searching mode. Check

whether there are too

many Bluetooth receivers

around your Bluetooth

device. Turnoff them to
avoid any interference and

pair again.

Cannot play
properly,

the music is
intermittent

Sound
distorted

Speaker
does not
power up

Bluetooth device and

speaker distance too

much far away,

Sound source is
distorted.

Low battery

Check whether the distance
between speaker and your

Bluetooth device is out of

its working distance, or

whether there are some

obstacles block the

streaming between speaker
and Bluetooth device.

Check the volume setting

on both speaker and your

Bluetooth device and
adjust the volume to a
proper level.

Ensure the Power switch

at the bottom of the

speaker is switched on.
Ensure the speaker is fully

charged or you have

connected the speaker to
power source

DISCLAIMER

Updates to hardware components are made regularly. Therefore
some of the instruction, specifications and pictures in this
documentation may differ slightly from your particular situation.
All item described in this guide for illustration purposes only and
may not apply to particular situation. No legal right or entitlements
may be obtained from the description made in this manual.

Swinton Avenue Trading, Inc.
Limited One (1) Year Product Warranty

This Limited Warranty covers the original purchase of new product

United States and Canada

used for normal commercial, personal or household use. Swinton
Avenue Trading, Inc. (SAT) warrants its products will be free from
defects in materials and workmanship (normal wear and tear
excepted), for ONE (1) YEAR from the original date of purchase,
except as provided below. If a defect exists, at its option SAT, will repair
or replace with a comparable product, free of charge, any product which
fails under normal use as a result of such defect. This warranty does
not apply to: (i) cosmetic damage, such as scratches, nicks and dents
or (ii) damage caused by water, fire, accident, negligence, abuse,
misuse, improper cleaning or other circumstances not directly
attributable to manufacturing defects.

Proof of purchase is required in the form of a receipt (a copy or a
original) to validate this Limited Warranty. If you do not have a copy
of your store receipt and paid using a check or a major credit card, a
copy can be obtained from
Office Depot’s receipt retrieval department at 1-800-721-6592.

If SAT chooses to provide a refund for such product, it will be fulfilled in
the form of an Office Depot Merchandise

Card. Claims fulfilled in this manner take approximately ninety (90)

days to process.

EXCLUSIONS AND LIMITATIONS

SAT PROVIDES THIS LIMITED WARRANTY IN LIER OF ALL OTHER
WARRANTIES EITHER EXPRESS OR IMPLIED. EXPRESSLY
EXCLUDED ARE ALL WARRANTIES OF FITNESS FOR A PARTICULAR
PURPOSE OR MERCHANTABILITY. SAT’S SOLE OBLIGATION AND
THE USER’S EXCLUSIVE REMEDY UNDER THIS WARRANTY
SHALL BE LIMITED TO THE REPAIR OR REPLACEMENT AT SAT’S

SOLE DISCRETION AND COST, OF THE PRODUCT OR
COMPONENTS.

IN NO EVENT SHALL SAT, ITS AFFILIATES, SUBSIDIARIES OR
PARENT COMPANIES BE RESPONSIBLE FOR CONSEQUENTIAL,
SPECIAL, OR INCIDENTAL DAMAGES ARISING OUT OF A CLAIM
OF DEFECTIVE PRODUCT EVEN IF SAT HAS BEEN ADVISED OF
THE POSSIBILITY OF SUCH DAMAGES.

SOME STATES OR PROVINCES DO NOT ALLOW THE EXLCUSION
OF IMPLIED WARRANTIES OR LIMITATIONS ON HOW LONG AN
IMPLIED WARRANTY LASTS OR THE EXCLUSION OR LIMITATIONS

OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE

LIMITATION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES

YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER

RIGHTS WHICH MAY VARY BY STATE OR PROVINCE.

THIS WARRANTY APPLIES ONLY TO THE U.S. AND CANADA.

Return Instructions

Please call 1-877-777-HELP (1-877-777-4357) for warranty service or

product support.