WOMIX MP06, MP10 Operating Instructions

C Comfort ontrols

Mixing valve actuator

MP 06, MP 10

Mounting and Operating Instructions

WOMIX

Ul. Elizy Orzeszkowej 11
89-200 Szubin
tel./fax [phone] fax [phone]
www.womix.com.pl e-mail: [e-mail]

Introduction

Thank you for your trust in our company and for purchasing modern and functional
actuator MP from WOMIX. This product will serve you for years and have a considerable impact
on energy-efficient heating.

The MP actuator

MP series actuators are compact and solid design. Under the plastic housing are located:
transmission with a maximum torque of 6 Nm actuator MP 06, 10 Nm actuator MP 10, a synchronous
motor, two limit switches. The MP actuator factory is equipped with a 1.5 meter cable 3 x 0.75.

Installation and use

Assembling the actuator can be made only installer with a valid permission and proper
preparation of technical implementation. Absolutely can not be installed by outsiders, who do not
have expertise on electric actuators, their working principles and the principles of connecting with
automatic installation. Thanks to a universal or special adapters or a different drive shafts of the
actuator assembly is practically possible wherever it is needed. Manual override actuator by
changing the position of the switch Manual / Automatic and rotation of the handle. The angle of
rotation of the actuator is factory set at 90° and can not be changed. Factory engine is equipped with
an adapter designed to be mounted on valves from the company WOMIX. The method of mounting
the actuator on the valve is presented step by step and is in the bag along with the appropriate
adapter. In order to mount valves from other manufacturers we offer special adapters. Mixing valves
which are mounted actuator should be before the start of each heating season "move by hand", ie.
Check that during downtime central heating, was not blocked heart of the valve. This action can
prevent the actuator from damage gear.

Specifications:

Nominal voltage: MP06/MP10: 230V, 50/60Hz or 24 V, 50/60Hz, (see actuator
model)

Power consumption: 3,5W, 3,5VA
For wire sizing: wire, 3 x 0,75mm , Długość - 2m
Torque: MP06 - 6 Nm (for nominal voltage)

MP10 – 10 Nm (for nominal voltage)

Angle of rotation: 90 Stopni,unregulated
Running time: 60, 135 seconds for the voltage 230 VAC

135 seconds for the voltage 24 VAC
Noise level: max. 35 dB (A)
Position indicator: stuck on the handle body
Switch to manual operation
Protection class: II
Degree of protection: IP 40
Operating Temperature Range: 0 - 50 C

0

Weight: 350 g

2

Dimesion:

Connection diagram MP 06

AC 24 V AC 230 V

N - the neutral wire - number 4

- the phase wire - number 3

- the phase wire - number 2

Always connect the the neutral wire to terminal N.

Terminal voltage causes a clockwise rotation of the actuator shaft.

Terminal voltage causes a counterclockwise rotation of the actuator shaft.

Changes in the direction of rotation can be made by replacing the cables on the terminals.

WARNING! Phase and zero can not be exchanged.