Wolo 365 User Manual

Your purchase of a WOLO horn is a perfect choice to

compliment your vehicle. Our horns are manufactured
with the finest of materials. Each horn is bench tested
before it is packaged to assure workmanship and quality,
so you will have many years of reliable service.

IMPORTANT: THIS HORN SHOULD NOT BE USED AS
A REPLACEMENT FOR VEHICLE‘S ORIGINAL
EQUIPMENT HORN. MODEL 365 IS NOT TO BE USED
AS A SIGNALING OR WARNING DEVICE. MODEL 365
THE ENFORCER™ IS FOR OFF THE ROAD AND
SHOW USE.

MOUNTING CONTROL KEYBOARD

1. Select a mounting location that will not interfere with
air bags or drivers vision.

2. Using the double-sided foam adhesive tape provided,
mount the keyboard to selected location. Make sure that
mounting surface is free from dust, wax etc. A clean
surface is necessary so that double-sided tape will hold
properly. IMPORTANT: ADHESIVE HOLDING POWER

BECOMES MAXIMUM IN ABOUT 24 HOURS. LIMIT
MOVING OR PUTTING PRESSURE ONTO THE
KEYBOARD UNTIL THEN.

MOUNTING SPEAKER

3. Select a convenient location in the engine
compartment that is dry and safe from the engines
exhaust manifold heat. Always face the speaker in a
downward position. This will help prevent water from
entering into the speaker. Using the speakers mounting
bracket as a template, mark hole locations (3) and drill
using a 1/8 inch drill bit. Secure speaker with self tapping
screws provided (3). Make sure that the speakers
opening is not blocked by any components which could
reduce its loudness.

WIRING

4. TWIN BLACK is connected to the speaker in the
engine compartmnt. Route wires through fire wall to
speaker. Connect either wire to one of the speaker wires.
Then connect remaining wire to other speaker wire.

5. RED WIRE, is connected to the fuse-block or a under
dash wire that has power (+) 12 volts when the ignition is on.
IMPORTANT: To protect your horn and vehicle, use the in­line fuse provided and wire as shown.

6. SINGLE BLACK WIRE, is grounded. Secure wire under a
bolt in the dashboard area, make sure that the METAL
surface around the bolt is clean of rust and paint to make a
good electrical connection.

TESTING

7. Make sure all wires are secured and connections are
properly taped.

8. Put the vehicle‘s ignition on to power the Enforcer™
Horn during testing.

9. Press each of the four (4) buttons on the keyboard
and The Enforcer™ will sound either one of three the
siren or the air horn sounds.

If you need help installing your new Wolo horn, our technicians are
available to answer your questions, Monday thru Friday, from 9 AM
to 4 PM EST at 1-888-550-4676.

Warranty

Wolo Manufacturing Corporation (“Wolo”) warranties to the
original purchaser, for three months from the date of
purchase, that the product is free from defects in
workmanship and materials. If there is such a proven defect,
Wolo, at its option, will either repair or replace the item free
of charge, if it is returned to Wolo within three months from
the date of purchase together with proof of purchase as
described below. Wolo reserves the right to inspect any
defect prior to settling any warranty claim by repair or
replacement. This warranty is limited as above provided and
Wolo will not be responsible for fire or other casualty or
accident, due to neglect, abuse, abnormal use, modifications,
faulty installation of this product, or natural causes.

MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR
PURPOSE ARE EXPRESSLY LIMITED TO A TERM OF THREE
(3) MONTHS. UNDER NO CIRCUMSTANCES SHALL WOLO
BE LIABLE TO PURCHASER OR ANY OTHER PERSON FOR
ANY SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER
ARISING OUT OF BREACH OF WARRANTY OR OTHERWISE.

To obtain warranty service, return the product prepaid, and
include the original bill of sale showing the date of purchase.
Include a brief description of the problem and your telephone
number. Also, include a check or money order in the amount of
$10.00 to cover return shipping.

Mail to:
Wolo Manufacturing Corp.,

One Saxwood Street, Deer Park, NY 11729
Attn: Warranty Service E-mail: [e-mail]

Installation and Operating Instructions for

MODEL 365 THE ENFORCER™

ELECTRONIC HORN

This horn is for OFF THE ROAD AND SHOW USE

MANUFACTURING CORP. - Deer Park, New York 11729

Visit Wolo on the World Wide Web: http:/www.wolo-mfg.com

©2005 Wolo Mfg. Corp.

All Rights Reserved