Wolfgang Puck BIBC1025 User Manual

IMPORTANT NOTICE

PLEASE DO NOT RETURN TO STORE.

If you have any problems with this unit,

contact Consumer Relations for service

PHONE: [phone].

Please read operating instructions

before using this product.

Please keep original box and packing materials

in the event that service is required.

W.P. APPLIANCES, INC.
Toll Free [phone] Email address: [e-mail]
Website: www.wolfgangpuck-kitchenware.com

All trademarks, service marks and trade names (collectively the “Marks”) are proprietary
to Wolfgang Puck World Wide.

Model BIBC1025 Printed in China REV 1.0

PUCK

WOLFGANG

Immersion
Blender/
Chopper
Manual

Important Safeguards

When using electrical appliances, basic safety precautions should always be
followed, including the following:

1 Read all instructions carefully.

2 To protect against risk of electrical shock, do not put motor base, cord or

plug of the appliance in water or other liquid.

3 Close supervision is necessary when any appliance is used by or near children.

4 Turn unit off and unplug from outlet when not in use, before putting on or

taking off parts, and before cleaning. To disconnect, turn unit off, grasp plug,
and pull from the wall. Never yank on cord.

5 Avoid contact with moving parts. Keep hands, hair, clothing as well as

utensils, away from the cutting blade during operation to prevent injury
and/or damage to the chopper. A spatula may be used but only when the unit
is not running.

6 Blades are sharp; handle carefully.

7 Do not operate any appliance with a damaged cord or plug or after the

appliance malfunctions or is dropped or damaged in any manner. Return the
appliance to an authorized service facility for examination, repair, or
electrical or mechanical adjustment.

8 The use of attachments not recommended or sold by the appliance manufac-

turer may cause fire, electric shock, or injury.

9 Do not use outdoors.

10 Do not let cord hang over edge of table or counter or touch hot surfaces,

including the stove.

11 Mixing flammable non-food substances can be harmful.

12 When mixing liquids, especially hot liquids, use a tall container, or make

small quantities at a time to reduce spillage.

13 Do not use this appliance for other than intended use.

14 Do not operate in the presence of explosive and/or flammable fumes.

15 This appliance is intended for HOUSEHOLD USE ONLY.

Save These Instructions

This appliance has a polarized plug (one blade is wider than the other).
As a safety feature, this plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to defeat this safety feature.

Before Your First Use

Carefully unpack the blender and accessories, and remove all packaging materials.
Wash the chopper bowl, chopping blade, blade attachments, and hand blender
attachment in warm, soapy water to remove any dust that may have accumulated
during packaging. Do not immerse the bowl cover, motor base, cord or plug in
water. Wipe the motor base and bowl cover with a damp cloth.

CAUTION: The attachment blades are very sharp. Use care when handling.

2

1

3

Table of Contents

Important Safeguards 1

Before Your First Use 2

About Wolfgang Puck 3

Know Your Immersion Blender 5

Hand Blender Attachment 6

Suggested Uses 7

Food Chopper Attachment 8

Helpful Hints 9

Care and Cleaning 10

Recipes 11

Recipe Notes 25

Limited Warranty 26

Contact Information back

Wolfgang Puck,

owner of the famous
Spago restaurants and
one of the most influential
chef-restauranteurs in
America, is credited with
reviving California’s rich
culinary heritage. His cooking
innovations, a result of

blending fresh California
ingredients with his classical French techniques, are enjoyed by world leaders,
stars and fellow chefs alike. He established other trend-setting restaurants
like Postrio in San Francisco, Chinois on Main in Santa Monica, Granita,
Vert and Trattoria del Lupo. Home chefs can also share Mr. Puck’s talents
through his cookbooks and, of course, through his appliances!

Know Your

Immersion Blender/Chopper

5

Mixing
Beaker •

Motor Base •

On / Turbo
Buttons •

Aerator Disc • Blending Disc •

Attachment removal tool •

Wire
Whisk •

Bowl cover •

Chopping Blade •

(for chopping bowl only)

Blending
Rod •

Grinding Blade •

Multipurpose Blade •

Chopper bowl
and Lid •

6

Speed Selector •

Assembly and Use

of Hand Blender Attachment

1 Ensure the motor base is unplugged. Attach

hand blender rod to motor base by holding the
motor base with the arrows slightly to the right
of the arrows on the blending rod. Turn the
motor base counter clockwise while holding
the blending rod firmly. (see figure 1)

2 Place one of the small metal attachments in the

shaft of the mixing rod. Make sure that the pin
located on the shaft fits into the groove of the
attachment. Press down until attachment locks
in place. (see figure 2)

Caution: Blades are sharp. Handle with care.

3 Place food in suitable container for mixing

(beaker, bowl, pan). For best results, solid foods
should be no larger than 1/2" cubes.

4 Plug into 120-volt 60 Hz AC only outlet.

5 Immerse the hand blending rod into your

ingredients. Turn the speed selector to “1” first.
Press the ON/OFF switch to begin blending;
then gradually increase speed, as needed. (see
figure 3) Slowly move the rod up, down and
sideways through the food . Note: Never
lift the hand blender attachment out of your
ingredients while the unit is running to avoid
splatter of your food.

6 At any time during the blending process, you can

press the Pulse button to increase the blender to
its maximum speed

7 Do not operate the motor continuously for more

than one minute when using the blender.

8 When you are finished, simply release the

ON/OFF switch, unplug the motor base, twist
the hand blending rod to remove.

9 To remove blades from the blender rod, use your

blade removal tool as shown in figure 4. Slide
the opening of the tool underneath the blade
and press down.

figure 1

figure 2

Shaft Pin

Blade
Groove

figure 3

figure 4

7 8

Beat cream, whip egg whites,
puddings, sauces, frostings and other
airy, foamy mixtures. When using, move
blending rod up and down to draw air
in. Use a tall, narrow container for best
results when foaming milk, making
cream and whipping egg whites.

Mix and stir shakes, drinks, omelet
batters, sauces and emulsions. Use for
pancake batter, gravies and dressings.

Cut, chop, and crush raw or cooked
meat and hard vegetables.Grind
cooked meat for use in recipes such
as casseroles or chicken salad.

Chop, crush, and mash vegetables, and
fruit for baby food, soups and sauces.

Assembly and Use

of Food Chopper Attachment

1 Ensure the motor base is unplugged.

2 Assemble chopper bowl by first placing the

chopping blade onto the blade shaft in the
chopper bowl. (see figure 1) Then place food in
bowl. For best results, solid foods should be no
larger than 1/2" cubes.

3 Place the chopper bowl lid on top of the

chopper bowl. (see figure 2)

4 Attach motor base to top of bowl cover by

turning clockwise.

5 Plug into 120-volt 60 Hz AC only outlet.

6 Attach the motor base to the chopping bowl

as follows: Hold the cover firmly with one hand,
while holding the motor base with the arrows
slightly to the right of the arrows on the bowl
lid. Turn the motor base counter clockwise.
(see figure 3)

7 Always use slight downward pressure when

operating the motor base, while the other hand
is placed firmly on the bowl cover. Always
ensure your speed selector is on “5” when
chopping. Use a pulse action when chopping by
pressing and releasing ON/OFF switch.

8 Do not operate the motor continuously for

more than 15 seconds when using chopper
attachment, otherwise food will be too
finely chopped.

9 When you are finished, simply release the

ON/OFF switch, unplug the motor base, and
then unscrew the chopper bowl.

figure 1

figure 2

figure 3

Suggested Uses

To change the metal attachment blade, remove the attachment already inserted
on the shaft of the mixing rod with the tool provided. Use the side of the tool with
the semi-circular slot to remove the attachment. Place the slot around the shaft,
underneath the attachment, and lift up to remove.

Caution: Blades are sharp. Handle with care.

Attachment Functions Speed

Aerator disc Minimum

Blending disc Medium to

Maximum

Grinding blade Maximum

Multipurpose blade Medium to

Maximum