Wolf Appliance Company L522212 User Manual
P RO V ENTILATION H OOD L INERS
INSTALLATION INSTRUCTIONS
CONTACT
INFORMATION
Wolf Customer
Service:
800-332-9513
Website:
wolfappliance.com
As you follow these instructions, you will
notice WARNING and CAUTION symbols.
This blocked information is important for the
safe and efficient installation of Wolf equipment. There are two types of potential
hazards that may occur during installation.
WOLF®is a registered trademark of Wolf Appliance Company, Inc.
signals a situation where minor injury or
product damage may occur if you do not
follow instr
states a hazard that may cause serious
injury or death if precautions are not
followed.
Another footnote we would like to identify is
IMPORTANT NOTE: This highlights information that is especially relevant to a problemfree installation.
uctions.
WOLF PRO VENTILATION HOOD LINERS
INSTALLATION REQUIREMENTS
IMPORTANT NOTE:
completed by a qualified installer or Wolf
uthorized service center technician.
a
nstaller:Please read the entire Installation
I
Instructions prior to installation. Save these
instructions for the local inspector’s refer-
nce, then leave them with the homeowner.
e
Homeowner:
instructions for future reference and be sure
to read the entire Use & Care Information
prior to use.
Any questions or problems about the
installation should be directed to your Wolf
dealer or Wolf Appliance Company, Inc. at
800-332-9513. You can also visit our website
at wolfappliance.com.
IMPORTANT NOTE:
installed in accordance with National Electrical
Codes, as well as all state, municipal and local
codes. The correct voltage, frequency and
amperage must be supplied to the appliance
from a dedicated, grounded circuit which is
protected by a properly sized circuit breaker or
time delay fuse. The proper voltage, frequency,
and amperage ratings are listed on the product
rating plate.
Record the model and serial numbers before
installing the hood liner. Both numbers are
listed on the rating plate, located inside the
left wall of the hood liner shell. Refer to the
illustration below
This installation must be
Please read and keep these
This appliance must be
.
WARNING – TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A)
Installation work and electrical
wiring must be done by qualified
person(s) in accordance with all
applicable codes and standards,
including fire-rated construction.
B)
When cutting or drilling into wall
or ceiling, do not damage electrical
wiring and other hidden utilities.
C)
Ducted fans must always be
vented to the outdoors.
To reduce the risk of fire and to
properly exhaust air, be sur
duct air outside. Do not vent
exhaust air into spaces within
walls or ceilings or into attics,
crawl spaces or garages.
RATING PLATE
INFORMATION
Model Number
Serial Number
e to
Rating plate located
inside hood liner shell
Rating plate location
Dimensions in parentheses are in
millimeters unless otherwise specified.
3
WOLF PRO VENTILATION HOOD LINERS
ACCESSORIES
Optional accessories are available
through your
Wolf dealer. To
obtain local dealer
information, visit
the Locator section
of our website,
wolfappliance.com.
INSTALLATION REQUIREMENTS
LIST OF MATERIALS
he following is a list of materials shipped
T
with the Wolf Pro ventilation hood liner.
Stainless steel hood liner
ransition with backdraft damper (attached
T
inside hood liner—needs to be removed)
Filters (installed in hood liner)
Installation package (taped to filters)
includes:
(8) #10 x 2" (51) Phillips head wood screws
(8) #10 washers
(4) hollow wall anchors
Installation Instructions
Use & Care Information and product
registration card
INSTALLATION CONSIDERATIONS
IMPORTANT NOTE:
Wolf Pro ventilation hood
liners are recommended for use with all Wolf
ooking appliances and are available to accom-
c
modate 36" (914), 42" (1067), 48" (1219), 54"
(1372) and 60" (1524) wide hoods.
Proper installation is the responsibility
f the installer. Product failure due to
o
improper installation is not covered
under the Wolf Warranty. Refer to the Wolf
Pro Ventilation Hoods Use & Care
Information for warranty details, or visit
the Contact/Help section of our website,
wolfappliance.com.
Make sure you have the tools and materials
necessary for proper installation.
Any required service must be performed by
a Wolf authorized service center. Wolf is not
responsible for service required to correct a
faulty installation.
IMPORTANT NOTE:
Wolf Pro ventilation
hood liners are shipped without the blower
assembly. Wolf internal, in-line and remote
blower assemblies are available, refer to
page 14. Use only a Wolf blower with the Pro
hood liner
IMPORTANT NOTE:
Wolf recommends that
the Pro ventilation hood liner be installed
30" (762) to 36" (914) above the countertop.
ELECTRICAL REQUIREMENTS
Wolf Pro ventilation hood liners require a
separate, grounded 110/120 V AC, 60 Hz power
supply. The service should have its own 15
amp circuit breaker. Locate the electrical
supply within the shaded area shown in the
Installation Specifications illustration on
the following page.
You must follow all National Electrical Code
regulations. In addition, be aware of local
codes and or
dinances when installing your
service.
4
INSTALLATION INSTRUCTIONS
30" TO 36"
(762–914)
TO COUNTERTOP
30" TO 36"
(762–914)
TO COUNTERTOP
E
12" (305)
HEIGHT OF LINER
221/2" (572)
DEPTH OF LINER
WIDTH OF LINER
DECORATIVE HOOD
HOOD LINER
HOOD LINER
DECORATIVE HOOD
6"
(
152)
5"
(127)
LOCATION OF ELECTRICAL
TOP WIDTH
SUBTRACT 6" (152) FROM OVERALL WIDTH
1
2"
(305)
OVERALL
HEIGHT
OVERALL WIDTH
4
"
(102)
221/2" (572)
OVERALL DEPTH
1
2"
(305)
3
"
(76)
3
"
(76)
13/8" (35)
223/4"
(578)
OVERALL DIMENSIONS
PRO HOOD LINERS
Overall Widths 343/8" (873), 403/8" (1026),
6
4
3
(1178), 52
/8"
3
/8"
(1330)
and 583/8" (1483)
Overall Height
12" (305)
Overall Depth 221/2" (572)
hipping Weight (shell only) 44–65 lbs
S
(20–29 kg)
1
Dimensions may vary to
+
–
/8" (3).
INSTALLATION SPECIFICATIONS
Pro Hood Liners
Dimensions in parentheses are in
millimeters unless otherwise specified.
5
Loading...