Wolf Appliance Company L342212 User Manual
INSTALLATION GUIDE
Pro Ventilation Hood Liners
Contents
Important Note
Wolf Pro Ventilation Hood Liners . . . . . . . . . . . . . . . . . 3
Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation Considerations . . . . . . . . . . . . . . . . . . . . . . 5
Pro Hood Liner Specifications . . . . . . . . . . . . . . . . . . . 6
Pro Hood Liner Installation . . . . . . . . . . . . . . . . . . . . . . 8
Service Information . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Features and specifications are subject to change at any time
without notice. Visit wolfappliance.com/specs for the most
up-to-date information.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specified.
o ensure the safe and efficient use of Wolf equipment,
T
please take note of the following types of highlighted
information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION signals a situation where minor injury or product
damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
Wolf Pro Ventilation Hood Liners 3
wolfappliance.com/specs
Pro Hood Liner Installation
IMPORTANT NOTE: T
his installation must be completed
by a qualified installer or Wolf factory certified service.
Read this entire installation guide prior to installation and
save for the local inspector’s reference. The homeowner
should keep this installation guide for future reference.
This appliance must be installed in accordance with
National Electrical Codes, as well as all state, municipal
and local codes. The correct voltage, frequency and
amperage must be supplied to the appliance from a dedicated, grounded circuit which is protected by a properly
sized circuit breaker or time delay fuse. The proper
voltage, frequency and amperage ratings are listed on the
product rating plate.
Record the model and serial numbers before installing the
hood liner. Both numbers are listed on the product rating
plate, located inside the left wall of the hood liner shell.
Refer to the illustration below.
olf Pro Hood Liner
W
Model Number
Serial Number
RATING PLATE
Location of rating plate
(inside liner).
Safety Instructions 4
IMPORTANT INSTRUCTIONS
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR INJURY, OBSERVE THE FOLLOWING:
•
Installation work and electrical wiring must be
done by qualified person(s) in accordance with all
applicable codes and standards, including fire-rated
construction.
•
Two installers are recommended due to the size and
weight of the pro ventilation hood liner.
•
Install the pro ventilation hood liner only with a
blower manufactured by Wolf.
•
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
To reduce the risk of fire and properly exhaust air,
be certain to duct air outside. Do not vent exhaust
air into spaces within walls or ceilings or into attics,
crawl spaces or garages.
•
Ducted fans must always be vented to the outdoors.
Installation Considerations 5
wolfappliance.com/specs
Installation Considerations
Wolf pro ventilation hood liners are recommended for use
with all Wolf cooking appliances. The ventilation hood
should be at least as wide as the cooking surface and be
installed 30"
(762) to 36" (914) above the countertop.
• Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the Wolf warranty. Refer to the Wolf pro
ventilation hoods use & care guide for warranty details,
or visit the contact & support section of our website,
wolfappliance.com.
• Make sure you have the tools and materials necessary
for proper installation.
• Warranty service must be performed by Wolf factory
certified service. Wolf is not responsible for service
required to correct a faulty installation.
MATERIALS INCLUDED WITH HOOD LINER:
• Transition with backdraft damper—attached inside
hood liner (needs to be removed)
• Two control knobs
• Filters and grease cups (installed in hood liner)
• Installation package and hardware
• Installation guide, use & care guide and product
registration card
DECORATIVE HOODS
custom decorative hood can be created out of wood,
A
plaster, tile or metal. The shape of the decorative hood is
not critical as long as the hood liner fits completely inside
the hood. The decorative hood and liner must fit together
at the bottom edge in both width and depth. The height of
the hood does not have to match the height of the liner.
Interior dimensions of the decorative hood must exceed
exterior dimensions of the liner. Refer to pages 6–7 for
dimensions of the hood liner.
The lower
3
/4" (19) of the 4" (102) reveal is stainless steel
and the rest of the reveal is aluminum. Make sure the
bottom edge of the liner does not extend more than
(19) below the decorative hood for a finished look.
BLOWER ASSEMBLIES
3
/4"
Wolf pro ventilation hood liners are shipped without the
blower assembly. Internal, in-line and remote blowers are
available through your authorized Wolf dealer. For local
dealer information, visit the find a showroom section of
our website, wolfappliance.com.
The blower will vary in size and is dictated by the cooking
surface, the volume of air that needs to be moved and the
length of the duct run. Refer to ventilation recommendations in the Wolf design guide.
IMPORTANT NOTE: Use only a Wolf blower with the pro
hood liner.
Loading...