Wolf CSO24 Installation Manual
INSTALLATION GUIDE
Convection Steam Oven
Contents
Important Note
Wolf Convection Steam Oven . . . . . . . . . . . . . . . . . . . 3
Convection Steam Oven Specifications . . . . . . . . . . . 4
Convection Steam Oven Installation . . . . . . . . . . . . . 12
Service Information . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Features and specifications are subject to change at any time
without notice. Visit wolfappliance.com/specs for the most
up-to-date information.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specified.
o ensure the safe and efficient use of Wolf equipment,
T
please take note of the following types of highlighted
information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION signals a situation where minor injury or product
damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
Wolf Convection Steam Oven 3
T
E
M
P
M
O
D
E
L
I
G
H
T
W
A
T
E
R
T
I
M
E
O
F
F
P
O
W
E
R
O
N
wolfappliance.com/specs
Convection Steam Oven Installation
IMPORTANT NOTE: T
his installation must be completed
by a qualified installer or Wolf authorized service center
technician.
Read this entire installation guide prior to installation and
save for the local inspector’s reference. The homeowner
should keep this installation guide for future reference.
This appliance must be installed in accordance with
National Electrical Codes, as well as all state, municipal
and local codes. The correct voltage, frequency and
amperage must be supplied to the appliance from a dedicated, grounded circuit which is protected by a properly
sized circuit breaker or time delay fuse. The proper
voltage, frequency and amperage ratings are listed on the
product rating plate.
Record the model and serial numbers before installing
the convection steam oven. Both numbers are listed on
the product rating plate located on the left oven side trim.
The oven door must be open to view the rating plate.
Refer to the illustration below.
olf Convection Steam Oven
W
Model Number CSO24
Serial Number
RATING PLATE
Location of rating plate.
Convection Steam Oven Specifications 4
219/16" (
548)
BEHIND FRAME
177/8"
(454)
213/16"
(538)
231/2" (597)
297/8" (759)
W
ITH TRIM
219/16"
(548)
143/16"
(360)
1
"
(25)
SIDE VIEW OVEN DOOR OPEN
(TOP VIEW)
FRONT VIEW
213/16"
(
71)
Overall Dimensions
CONVECTION STEAM OVEN
odel CSO24
M
Convection Steam Oven Specifications 5
wolfappliance.com/specs
Convection Steam Oven
he convection steam oven can be installed with or
T
without side trim in a standard or flush inset application.
The installation opening must have a flat, level base to
support the oven. A minimum base support of 100 lbs
(45 kg) is required. The electrical supply for the oven must
be located in an adjacent cabinet.
STANDARD INSTALLATION
For standard installations, the convection steam oven is
installed by inserting into cabinetry from the front. The
oven has face trim on the top and both sides that will
overlap stiles and rails. Refer to the chart below for trim
overlaps.
Oven Trim Overlap
Top Overlap
Bottom Overlap 0" (0)
Side Overlap (without trim)
Side Overlap (with trim) 313/16" (97)
3
/16" (5)
5
/8" (16)
FLUSH INSET INSTALLATION
COMBINATION INSTALLATIONS
The Wolf convection steam oven with trim is designed
and agency approved for installation with Wolf cooktops,
built-in ovens, microwaves and warming drawers only.
If it is being installed above or below an E series oven in a
flush inset application, a
1
/4" (6) reveal is required.
For typical combination installations, refer to the illustrations on pages 9–11.
For flush inset installations, a minimum1/8" (3) reveal is
required on all four sides. The inside edges of the rough
opening must be finished, as they will be exposed when
the oven door is open. These edges should be stained
instead of having a laminated surface, to avoid damage
from high temperatures and steam.
Loading...