Wolf ASA24 Specifications
GRIDDLES & CHARBROILERS
ASA SERIES
HEAVY DUTY GAS GRIDDLES
Model ASA48
SPECIFICATIONS
Low prole heavy duty gas griddle, Wolf Model No._______.
Stainless steel front, sides and front top ledge. Fully welded
stainless and aluminized steel body frame. 11" low prole
cooking height on 4" legs. 1" thick polished steel griddle
plate with 12 gage, 4" stainless steel back and tapered side
splashes. Grease chute is fully welded to stop grease migration.
One 27,000 BTU/hr. “U” shaped aluminized steel burner and
mechanical snap action thermostat for each 12" of griddle
width. Temperature adjusts from 200° to 550° F. One pilot
safety for every two burners. 3½" wide stainless steel grease
trough. ¾" rear gas connection and gas pressure regulator.
Exterior Dimensions:
_____"w x 33" d x 15½" h on 4" legs.
CSA design certied. NSF listed.
SPECIFY TYPE OF GAS WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 3,999 FT.
Item # C.S.I. Section 11420
ASA24 24" w x 24" d griddle plate
ASA36 36" w x 24" d griddle plate
ASA48 48" w x 24" d griddle plate
ASA60 60" w x 24" d griddle plate
ASA72 72" w x 24" d griddle plate
STANDARD FEATURES
Stainless steel front, sides and front top ledge with “Cool ■
Bullnose” design.
Fully welded stainless and aluminized steel chassis frame. ■
11" low prole cooking height on 4" adjustable legs. ■
1" thick polished steel griddle plate with 12 gage, ■
4" stainless steel back and tapered side splashes.
Spatula wide 3½" grease gutter and chute is fully welded ■
for easier cleaning and to stop grease migration.
One 27,000 BTU/hr. “U” shaped aluminized steel burner for ■
every 12" of griddle width.
One embedded snap action thermostat per burner with ■
temperature adjust from 200°F to 550°F.
Large 6 quart stainless steel grease drawer (2 drawers on ■
60" and 72" models).
One pilot safety valve for every two burners. Safety will ■
completely shut off gas to pilot and burners if pilot
extinguishes.
Manual ignition. ■
Bottom heat shields. ■
¾" rear gas connection and gas pressure regulator. ■
One year limited parts and labor warranty. ■
OPTIONAL FE ATURES
30" deep plate.
Stainless steel stand with marine edges and casters.
Cutting board, condiment rail, plate rail and banking strip
accessories.
a divisi on of IT W Food Equ ipmen t Group LLC
P.O. Box 696 ■ Louisville, KY 40201 ■ Toll-free: 1-800-814-2028 ■ Local: 502-778-2791 ■ Quote & Order Fax: 1-800-444-0602
F38321 (05/10)
GRIDDLES & CHARBROILERS
6 QUART
CAPACITY
GREASE CAN
24", 36", 48", 60", 72"
[610, 914, 1219, 1524, 1859]
19.5", 31.5", 43.5", 55.5", 67.5"
[495, 800, 1105, 1410, 1715]
15.25"
[387]
4 - 5.75”
[102 - 146]
ADJUSTABLE
LEG
3.42” [91]
MANIFOLD
PIPE TYP
7.70"
[196]
11.38"
[289]
3.47"
[89]
4"
[102]
5.0” [122]
MANIFOLD11.18” [284] TO COOK SURFACE
20.13” [511] STANDARD UNIT
26.13” [664] DEEP UNIT
31.5” [800] STANDARD UNIT
37.5” [953] DEEP UNIT
24” [610] STANDARD UNIT
30” [763] DEEP UNIT
1” [25] THICK GRIDDLE PLATE
ASA SERIES
HEAVY DUTY GAS GRIDDLES
INSTALL ATION INSTRUCTI ONS
1. A gas pressure regulator supplied with the unit must be installed;
Natural Gas 4.0" (102 mm) W.C.
Propane Gas 10.0" (254 mm) W.C.
2. All models require a 6" (152 mm) clearance at both sides and
rear adjacent to combustible and 0" from non-combustible
constructions. All models require a 4" (102mm) bottom clearance
and must be installed with minimum 4" legs.
3. These units are manufactured for installation in accordance with
ANSI/NFPA-70, National Electrical code.
An adequate ventilation system is required for Commercial
Cooking Equipment (NFPA No. 96). Information may be
obtained by writing to the National Fire Protection Association,
Batter ymarch Park, Quincy, MA 02169.
4. These units are manufactured for installation in accordance with
National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition).
Copies may be obtained from The American Gas Association,
Accredited Standards Committee Z223 @ 400 N. Capital St. NW,
Washington, DC 20001, or the Secretar y Standards Council,
NFPA, 1 Batterymarch Park, Quincy, MA 02169-7471.
NOTE: In The Commonwealth of Massachusetts
All gas appliances vented through ventilation hood or exhaust
system equipped with a damper or with a power means of
exhaust shall comply with 248 CMR.
5. This appliance is manufactured for commercial installation only and
is not intended for home use.
FRONT VIEW
OVERALL
MODEL WIDTH DEPTH
HEIGHT*
ASA24 24" 311⁄2" 151⁄4" 111⁄8" 2 54,000 1 285 lbs./129 kg.
ASA36 36" 311⁄2" 151⁄4" 111⁄8" 3 81,000 1 400 lbs./181 kg.
ASA48 48" 311⁄2" 151⁄4" 111⁄8" 4 108,000 1 480 lbs./218 kg.
ASA60 60" 311⁄2" 151⁄4" 111⁄8" 5 135,000 2 650 lbs./295 kg.
ASA72 72" 311⁄2" 151⁄4" 111⁄8" 6 162,000 2 790 lbs./358 kg.
*These are nominal dimensions and can vary by +1.75" with adjustable legs.
F38321 (05/10)
P.O. Box 696 ■ Louisville, KY 40201 ■ Toll-free: 1-800-814-2028 ■ Local: 502-778-2791 ■ Quote & Order Fax: 1-800-444-0602
NOTE: In line w ith its p olicy to continually imp rove its products, Wolf re ser ves the ri ght to cha nge mate rials and spe cica tions without n otice.
a divisi on of IT W Food Equ ipmen t Group LLC
WORKING
HEIGHT*
NO. OF
BURNERS
SIDE VIEW
TOTAL
BTU/HR.
NO. OF
DRAWERS
APPROX.
SHIP. WT.
Loading...