CONTENTS OF THE BOX:
• 1 x Helicopter
• 1x Remote (6x AA-batteries not included)
• 2x 3.7V 120mAh Li-po battery
• 1x Charge station
• 1x Tailrotor
• 2x Spare blade
SPECIFICATIONS:
• 4 channel ready to fly helicopter
• 1 Mainmotor, 1 Tailmotor
• 2x Li-po 3,7 Volt 120mAh accu's
• Height: 82mm
• Length: 220mm
• Width: 54mm
• Weight: 32 gram
• Battery weight: 8 grams
Specifications
Security precautions
• This model is not suitable for children under 14 years and contains small parts
• Keep hands, face, hair and clothes away from blades.
• The model and the transmitter must be switched off after use
• Children should only use this model under the supervision of an adult
• Stand out of reach of moving parts of the copter
• Always fly in an open and safe environment where you will not cause any danger to others
• For the remote control, we recommend AA batteries with a voltage of 1.5 to 1.2 volts
• Keep these instructions safe
• Read the manual carefully and completely
• After using the copter ALWAYS disconnect the battery and remove it from the device
• Before each flight, test the distance limit of the transmitter
• Always follow local laws and regulations! Contact your reseller when in doubt.
• For people without experience, we recommend that you learn to fly with an experienced user during your first flights
V911 HELICOPTER
INSTRUCTION MANUAL
Copyright WLtoys.eu | DroneX BV
The user must return used batteries and rechargeable batteries.
It is forbidden to dispose of used batteries in the bins containing
household waste! Batteries / accumulators containing
hazardous substances are marked with the crossed out wheelie
bin. The symbol indicates that the product should be recycled.
The chemical symbols for the respective hazardous substances
are Cd (cadmium), Hg (mercury), Pb (lead). The used batteries
can be disposed for free of charge at collection points in your
community, stores or wherever batteries are sold. You are kindly
requested to conform to your legal obligations and contribute to
the protection of our environment.
Battery recycling recommendations
DO NOT FLY:
- Around people or animals
- Around large groups of people
- In limited visibility or dark conditions
- Winds above 2 Beaufort
- Near high voltage pylons and / or other types of cabling
- During thunderstorms, rain or high humidity. The device is not water-resistant.
For the sensitive and rational conservation, protection and improvement of the quality of the environment, protection of human
health and the preservation of natural resources, the user must send an unusable product to relevant facilities created to this
purpose in accordance with the law.
The crossed out wheelie bin means that the product must be recycled (WARNING: do not throw it in your bin).
Li-po Battery instructions
Copyright WLtoys.eu | DroneX BV
- Keep the batteries out of reach of children
- Non-rechargeable batteries should not be recharged
- Unequally charged batteries or different battery types should
not be used together
- Use recommended batteries or similar
- After using the copter, remove the batteries if you will not use
it again for a long period of time
- The terminals must not be short-circuited
- This model is equipped with a rechargeable Li-po Battery. Lipo batteries require special attention, follow the manual
- The batteries must be charged with the charger supplied by
WLtoys
- When charging the battery, always ensure that you do so on a
non-combustible surface
- Do not leave charging without supervision
- Always charge the battery to 100%
- Ensure that the battery wires are not in contact to avoid a
short-circuit
- The ignition wires of the battery must not be modified or
damaged
- Never damage the battery mechanically (this could cause an
explosion)
- The battery should not be placed near children (unless you
have an adult supervision)
- The technical design of the battery must not be changed
- Touching of damaged batteries can cause injury. If there is
contact with skin or eyes, seek medical attention immediately!
- Do not charge directly after the flight or when the battery is
warm
Option A : Via the remote wire (V252/V939/V911)
1. Wire
2. Support
3. LED
4. Batteries
Unplug the connector from the remote and put it into the
charging station. Switch on the remote and put one or both
batterie(s) in the charging station. The light of the charging
station will be red. After one hour the light will turn off meaning
that the battery is fully charged.
Option B : Via USB
Connect the USB plug of the charging station with a computer
or other electronic device. As soon as the charging station is
connected you will see a red light. After one hour the light will
turn off meaning that the battery is fully charged.
Please disconnect the charging station as soon as the red light
of the charging station is off.
Warning : Always place the battery on a heat resistant surface and never leave it unattended!
Remote Control / Transmitter
Battery charging
Copyright WLtoys.eu | DroneX BV
Loading...