WIZZILABS WM User Manual

Section of 996369 KDB D03 OEM
Manual

User’s Manual Instruction Rev 1.1

2.2 List of applicable FCC rules

This module has been approved under FCC part 15C (15.247)

2.3 Summarize the specific

The module is limited to OEM installation ONLY.

instruction to remove or install module.

2.4 Limited module procedures

The module is for use with external antenna only. The certified antennas include:

Class 2 Permissive Change must be filed with the FCC.

2.5 Trace antenna designs

Not Applicable (No PCB antenna trace possible)

2.6 RF exposure considerations

IMPORTANT NOTE: To comply with FCC RF exposure compliance

between the radiator and your body.

2.6 RF exposure considerations

End Product User’s Manual:

between the radiator and the body.”

2.7 Antennas

See 2.4 for the list of approved antennas.

WIZZILAB.

2.8 Label and compliance

End Product Labeling:

FCC ID: 2ARZVWM”.

2.9 Information on test modes and

If testing of the host product with this transmitter installed and operating is

test mode for this specific module is available upon request to WIZZILAB.

2.10 Additional testing, Part 15

This module has been approved under FCC part 15C (15.247).

certification. (For example, Part 15 Subpart B)

Apparatus: DASH7 RF Module
FCC ID: 2ARZVWM

MODULAR TRANSMITTER INSTRUCTION MANUALS

operational use conditions

(1) To the host product
manufacturer

(2) To end users in their end­product manuals

The OEM integrator is responsible for ensuring that the end-user has no manual

(1) ½ Wave Antenna with maximum gain 2.2dBi (Dipole antenna)
(2) ¼ Wave Antenna with maximum gain -1.3dBi.
This module has been approved by FCC to operate with the antenna types
above with the maximum gain at at the antenna feed of 13dBm. Antenna types
not included in this list, having a gain greater than the maximum gain indicated
for that type, are strictly prohibited for use with this device.
Specially, if an antenna other than the model documented in the filing is used, a

requirements, the antenna used for this transmitter must not be colocated or
operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance 20cm

The user manual for end users must include the following information in a
prominent location “IMPORTANT NOTE: To comply with FCC RF exposure
compliance requirements, the antenna used for this transmitter must not be
colocated or operating in conjunction with any other antenna or transmitter. The
equipment should be installed and operated with a minimum distance of 20cm

Additional information:
If the end host product is equipped with an external connector, then a unique
(non-standard) antenna connector must be used on the transmitter.
A list of acceptable non-standard connectors is available upon request to

information

additional testing requirements

Subpart B disclaimer

Applicant for this device:

WIZZILAB SAS
29 boulevard Romain Rolland
92120 MONTROUGE - FRANCE
Yordan TABAKOV

[e-mail]

[phone]

(CTO)

When the FCC ID is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must
also display a label referring to the enclosed module. This exterior label can be
use wording ”Contains transmitter module FCC ID: 2ARZVWM” or “Contains

necessary (to verify that the host product meets all the applicable FCC rules), a

This modular transmitter is only FCC authorized for this specific rule part.
The host product manufacturer is responsible for compliance to any other FCC
rules that apply to the host not covered by the modular transmitter grant of