Wi-Tek WI-PS518GF Installation Manual

LED Explanation

Power

Installation Guide

5/816/24/48-Port PoE

On: Power on

Off: Power off

PoE/Link

For 100M port:

Yellow light Solid On: Power supplying for PD.

Green light Solid On: PD connected to the PoE port,

but no data transmission.

Flashing: Data transmitting.

For 1000M port:

Yellow light Solid On: Running at 1000Mbps.

Green light Solid On: Running at 100Mbps.

Flashing: Transmitting/receiving data.

Note: For simplicity, we will take WI-PS518GF for example through this Guide.

Yellow

Green

SFP

Package Contents: Switch, Power cord, QIG, Rackmount Kit(except 5/8-port Model).

Functional switch

Frequently Asked Questions (FAQ) Functional switching Explain

If the Power LED is not lit, check as follows:

A1: Make sure the power adapter is connected to the switch

with power source properly.

A2:

Make sure the voltage of the power supply meets the

requirements

of the input voltage of the switch.

A3: Make sure the power source is ON.

Q2. The PoE/Link LED is not lit when a device is

connected to the corresponding port.

A1: Make sure that the cable connectors are firmly plugged

into the switch and the device， the Ethernet cable

should be pure cooper CAT5/5e/6.

A2: Make sure the PD is compatible to the switch, please check

detailed PIN information in the PIN definition table.

A3: The cable must be less than 100 meters long (328 feet) if it

doesn’t support the Extend function .

Gear

Function

Explanation

Default

Standard

All ports free communication, suitable for common

data transmission environment.

VLAN

Port

isolation

The 4 PoE ports are isolated from each other, which is

suitable for the use of wireless AP, which can

effectively restrain the network storm and improve the

performance of the wireless network.

Extend

250 meters

supply

Ultra far 250 meters PoE transmission , can solve the

monitoring project and wireless coverage project

power supply distance problem.

For technical support and other information,

please visit: www.wireless-tek.com

The PIN definition of Wi-Tek PoE

Warranty Card

For managed model, If you want to configure L2 advanced function,

please launch a browser and type 192.168.0.1 into address bar. The

default username and password are both admin in lower case.

Q1. The Power LED is not lit.