WisyCom MPR30-IEM, MPR30-ENG User Manual

MPR30 Manager

Products:
MPR30-IEM, MPR30-ENG

MPR30 Manager

Pag. 1

HOW TO USE MPR30 RX MANAGER

Wisycom MPR30 RX Manager can be used to load or save the channels memory and upgrade
the firmware.

Instruction to connect MPR30 using UPK300 / UPK300E:

1. Connect to the PC the infrared programming interface (UPK300 or UPK300E) using a

USB cable (NOTE: it is not possible to use IR interface of MRK950 or MRK960)

2. Check if the version of ENG RX Manager installed in your PC is the latest version. If

not, uninstall the ENG RX Manager actives in your PC and install the new version as
indicated in the section How to update ENG RX Manager .

3. Run ENG RX Manager

4. Power up the receiver MPR30 and enable the IRDA interface:

a. push button,

b. push button until that Infrared submenu appears on the display

(Headphones>Edit RX>Display>Infrared)

c. push again button and check the display shows ‘IR IF active’

5. Put in contact MPR30 and UPK300/UPK300E

6. Push Disconnected button. On the Device connection windows select UPK port and

verify that upk300 is
selected on the
Silabs USB devices
panel. If upk300
device is not
showed, push
Refresh button
and/or try to
disconnect and
reconnect the USB
cable connected to

MPR30 Manager

Pag. 2

the UPK300. Then click OK.

7. If the connection is ended well, the Connected icon is showed on the top of the

panel and “Connected on USB by UPK” is displayed on the information panel

MPR30 Manager

Pag. 3

Instruction to connect MPR30 using USB cable:

In order to use the microUSB port to configure the
MPR30, it is necessary to install the MPR30 USB
driver (see How to install MPR30 USB driver)

1. Connect the MPR30 to the PC thru the

micro USB interface using the USB cable

2. Check if the version of ENG RX Manager

installed in your PC is the latest version. If
not, uninstall the ENG RX Manager actives
in your PC and install the new version as
indicated in the section How to update ENG

RX Manager .

3. Run ENG RX Manager

4. Power up the receiver MPR30

5. Push Disconnected button. On the Device connection windows select USB port and

verify that a COMx is
selected on the Virtual
COM panel. If COMx is
not showed, push
Refresh button and/or
try to disconnect and
reconnect the USB cable
connected to the
MPR30. Then click OK.

6. If the connection

is ended well, the
Connected icon is
showed on the
top of the panel

and “Connected
on COMx” is

displayed on the
information panel