Wistron NeWeb VWL10 User Manual

CA10002

User’s Manual

This document provides instructions for installing the antenna and describes the requirements
and specifications of this product. The antenna can be mounted on a vertical or horizontal
surface, or on a slope. Read this document carefully before installing to ensure your safety and
product performance.

Contents

FEDERAL COMMUNICATION COMMISSION (FCC) INTERFERENCE STATEMENT ............ 3

BEFORE YOU START .................................................................................................... 3

IMPORTANT SAFETY INSTRUCTIONS .......................................................................... 3

UNPACKING INFORMATION ........................................................................................ 5

WIRING PLAN ............................................................................................................. 6

SELECTING AN INSTALLATION LOCATION .................................................................. 6

INSTALLING THE CANTENNA ...................................................................................... 7

LED INDICATORS ...................................................................................................... 11

PRODUCT SPECIFICATIONS ...................................................................................... 11

Federal Communication Commission (FCC)
Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:

- Reorient or relocate the receiving antenna.

- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

- Install an approved low pass filter

FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.

Before You Start

Carefully follow the warnings and safety notices in this manual. Please pay special attention to
the following indications of potentially hazardous situations:

Warning:

Indicates a hazardous situation, which, if not avoided, could result in serious injury or even
death.

Caution:

Indicates a situation, which, if not avoided, could damage this product or other devices.

Note:

Indicates additional information to alert the user to possible issues and to help the user
understand, use and maintain the product.

Important Safety Instructions

Caution:

These servicing instructions are for use by qualified service personnel only. To reduce the risk of
electric shock do not perform any servicing other than that contained in the operating
instructions unless you are qualified to do so.

Warning:

For your safety, follow these important safety precautions:

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this unit near water.

6) Clean only with dry cloth.

7) Do not block any ventilation openings. Install in accordance with the manufacturer’s

instructions.

8) Do not install near any heat sources such as radiators, heat registers, stoves, or other

apparatus (including amplifiers) that produce heat.

9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug

has two blades with one wider than the other. A grounding type plug has two blades and a
third grounding prong. The wide blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.

10) Protect the power cord from being walked on or pinched particularly at plugs, convenience

receptacles, and the point where they exit from the unit.

11) Only use attachments/accessories specified by the manufacturer.

12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or

sold with the unit. When a cart is used, use caution when moving the cart/unit
combination to avoid injury from tip-over.

13) Unplug this unit during lightning storms or when unused for long periods of time.

14) Refer all servicing to qualified service personnel. Servicing is required when the unit has

been damaged in any way, such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the unit, the unit has been exposed to rain or moisture,
does not operate normally, or has been dropped.

Warning:

When installing the product, you must take extreme care not to come into contact with electric
power lines. You risk serious injury or even death if the product is located near overhead
power lines, electric lights or power circuits. Be sure to maintain a safe distance before you
start any installation procedures. We recommend that you maintain a minimum distance of 20
feet (about 6 meters) from all power lines.

If any part of the product comes into contact with a power line, stay away from the product and
all its related components. DO NOT REMOVE IT YOURSELF. Call your local power company for
assistance.

Warning:

For your personal safety, follow these important safety precautions:

1. Do not install the product on a wet or windy day.

2. Perform as many of the installation procedures as possible on the ground.

3. When installing the product, if you accidentally drop any part of it, do not try to catch it. Let

it fall.

4. Installation of the product is usually performed by two or more people. Ensure that all

participants are well-trained and understand the tasks that they are assigned.

5. Do not use a metal ladder, or if you do make sure it has rubber feet installed. Metal ladders

can be deadly as they conduct electricity.

6. Wear shoes with rubber soles.