Wistron NeWeb UMDRT1 User Manual

24GHz Blind Spot Detection Radar

User Manual

V0.01

Content

Blind Spot Detection Radar System ...................................................... 1

Notice: ................................................................................................. 1

Radar and Warning System location .................................................... 1

Warning level ....................................................................................... 3

Detection range and warning systems.................................................. 4

Radar detection limitation ................................................................... 6

False alarms ......................................................................................... 7

Blind spot zone and the radar viewing area ......................................... 8

FCC Statement: .................................................................................... 9

24GHz Blind Spot Detection Radar

1

Blind Spot Detection Radar System

24GHz radar blind spot detection system (hereinafter referred
to as BSD system) is a set of auxiliary system which uses
radar sensor to detect road traffic conditions and visual blind
spot area. It is to provide alert information for driver when
changing lanes. This blind spot monitoring system set range
includes both sides and the rear of the vehicle. The system will
provide different warning level to remind drivers based on the
message of indicator for changing lane once target enter the
blind spot zone.

Notice:

 Blind spot detection system is not able to detect all the cars

in all cases. There is still the risk of accidents.

 Blind spot detection system can not be used to replace the

judgment of driving on the road, do not place undue
reliance on detection results. For changing lanes or similar
operations, driver still needs to concentrate and observe
the surrounding environment.

 If the rear car driving fast, blind spot detection system may

not react.

 Blind spot detection system will start detection

mechanisms with car speed 10 km / h or more.

 If the radar sensor system detects error, a warning light will

be turned on and maintained, this system will point out the
problem comes from left or right side of the sensor.

Radar and Warning System location

Blind spot detection system consists of two radar sensors and
a warning system

- Wistron NeWeb Corp. -

24GHz Blind Spot Detection Radar

2

Radar sensors are installed in the rear bumper of the left and
right sides (such as schematic in Figure 1). The radars on the
two sides help drivers detect vehicles.

(Figure 1)

If the radar sensor is obscured, it may not detect obstacles and
reduce system performance. To avoid radar sensor function is
affected, please pay special attention to the following points:

 Do not shield radar sensor foreign body parts (such as

stickers, bike rack, trailer).

 Avoid bumper was hit or damaged, if the above situations,

such as shock or damage, please contact the service
center as soon as possible and repair.

 Ensure that the soil/ snow or ice on the site of the radar

sensor has been cleared..

Warning system will be installed in the driver's seat and front
passenger side A-pillar (as shown in Figure 2).

(Figure 2)

- Wistron NeWeb Corp. -