Wistron NeWeb RB8 User Manual

WLAN 802.11g Cardbus
User Manual
Model: RB8
Version: 1.0
Jun. 2003
1
Copyright Statement
All copyright reserved.
2
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, (example - use only shielded interface cables when connecting to computer or peripheral devices) any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference
that may cause undesired operation.
IMPORTANT NOTE:
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The user cannot use channel 12 & 13, or it will be a violation of the sensiti ve restricted b ands of 15.205.
3
Table of Contents
1. INTRODUCTION 4
1.1 THE WLAN 802.11G CARDBUS ..............................................................................4
1.2 FEATURES ................................................................................................................4
1.3 KIT CONTENTS ........................................................................................................5
1.4 THE CARDBUS LEDS...............................................................................................5
2. PLANNING YOUR WIR ELESS NETWORK 6
2.1 NETWORK TOPOLOGY.............................................................................................6
2.2 AD-HOC VERSUS INFRASTRUCTURE MODE............................................................6
3. SOFTWARE INSTALLATION AND UNINSTALLATION 8
3.1 SETUP WIZARD INSTALLATION.......................................................................8
3.2 ADDITIONAL SETUP PROCESSES ...........................................................................11
3.3 DISABLE WINDOWS XP ZERO-CONFIGURATION .................................................12
3.4 UNINSTALLATION...................................................................................................13
4. USING THE CONFIGURATION UTILITY 15
4.1 OVERVIEW .............................................................................................................15
4.2 ACCESSING THE CONFIGURATION UTILITY .........................................................15
4.3 LINK STATUS ..........................................................................................................19
4.4 SITE MONITOR.......................................................................................................20
4.5 STATISTICS.............................................................................................................21
4.6 DIAGNOSTICS.........................................................................................................22
4.7 INFORMATION........................................................................................................23
APPENDIX A: TROUBLESHOOTING24
APPENDIX B: GLOSSARY 28
APPENDIX C: SPECIFIC ATION 33
4
1. Introduction
1.1 The WLAN 802.11g Cardbus
802.11g is the 54Mbps wireless networking standard that's almost five times faster
than the widely deployed 802.11b products found in homes, businesses, and public wireless hotspots around the country — but since they share the same 2.4GHz radio band, 802.11g devices can also work with existing 11Mbps 802.11b equipment. The new 802.11g Cardbus has both standards built in, so you can connect your notebook to existing 802.11b infrastructure, and also the new screaming fast 802.11g networks. The included Setup Wizard will walk you through configuring the cardbus to your network's settings, step by step. Then just slide it into your notebook's PC Card slot and enjoy network access with your notebook computer, while retaining true mobility.
Once you're connected, you can keep in touch with your e-mail, access the Internet, and share files and other resources such as printers and network storage with other computers on the network, wherever you wander. At home, you can surf the web or use instant messaging to chat with friends while sitting out on the patio. You'll also be able to connect with any of the growing number of public wireless hotspots springing up in coffee shops, airport lounges, hotels and convention centers. And as those hotspots upgrade to the new high-speed 802.11g standard, you'll be ready to take advantage of the increased speeds. Get connected to current-standard 802.11b networks today, and be prepared for the future with the 802.11g Cardbus.
1.2 Features
l High-speed 802.11g networking for your notebook computer l Data rates up to 54Mbps -- 5 times faster than 802.11b l Also interoperates with 802.11b networks (at 11Mbps) l Wireless security -- up to 128-bit WEP encryption
5
1.3 Kit Contents
l WLAN 802.11g Cardbus l Installation Software CD with User’ s Manual l Quick Start Guide
1.4 The Cardbus LEDs
Link LED
Power LED
Power Green. The Power LED lights up when the Cardbus is powered
on.
Link Green. The Link LED lights up and stays solid when the Cardbus
is inserted correctly and a link is established with the Notebook. The LED flashes when data is transmitted or received..
6
2. Planning Your Wireless Network
2.1 Network Topology
A wireless local area network (WLAN) is exactly like a regular local area network (LAN), except that each computer in the WLAN uses a wireless device to connect to the network. Computers in a WLAN share the same frequency channel and SSID, which is an identification name for wireless devices.
2.2 Ad-Hoc versus Infrastructure Mode
Unlike wired networks, wireless networks have two different modes in which they may be set up: infrastructure and ad-hoc. An infrastructure configuration is a WLAN and wired LAN communicating to each other through an access point. An ad-hoc configuration is wireless-equipped computers communicating directly with each other. Choosing between these two modes depends on whether or not the wireless network needs to share data or peripherals with a wired network or not.
If the computers on the wirel ess network need to be accessed by a wired network or need to share a peripheral, such as a printer, with the wired network computers, the wireless network should be set up in infrastructure mode. (See Figure 2-1.) The basis of infrastructure mode centers around an access point, which serves as the main point of communications in a wireless network. Access points transmit data to PCs equipped with wireless network cards, which can roam within a certain radial range of the access point. Multiple access points can be arranged to work in succession to extend the roaming range, and can be set up to communicate with your Ethernet (wired) hardware as well.
Figure 2-1
7
If the wireless network is relatively small and needs to share resources only with the other computers on the wireless network, then the ad-hoc mode can be used. (See Figure 2-2.) Ad-hoc mode allows computers equipped with wireless transmitters and receivers to communicate directly with each other, eliminating the need for an access point. The drawback of this mode is that, in Ad- Hoc mode, wireless-equipped computers are not able to communicate with computers on a wired network. And, of course, communication between the wireless-equipped computers is limited by the distance and interference directly between them.
Figure 2-2
8
3. Software Installation and Uninstallation
Note! The Installation Section in this User Manual describes the first-time installation
for Windows. To re-install the driver, please first uninstall the previously installed driver. See Chapter 3.2 “Uninstallation” section in this User Manual.
Note! Do Not insert the Cardbus into the Cardbus slot before the driver installation.
Note! If you have inserted the Cardbus into the Cardbus slot before installing the
driver, a warning message pops up informing you that the software has not yet been installed. Please click “Cancel” to close the warning message. Remove the Cardbus, and then start to install the driver.
3.1 Setup Wizard Installation
Follow the steps below to complete the driver/utility installation:
1. Insert the Installation Software CD into the CD-Rom Drive.
2. Click “Next”.
9
3. Read the License Agreement and click “Yes” .
4. Click “Next” to continue or click “Browse” to choose a destination folder.
5. Click “Next”.
6. Click “Finish”.
7. Insert the Cardbus with the Cardbus’ s label facing up into the Cardbus slot
8. The Windows Operating System will find the new hardware and automatically
install it. (For Windows 98SE or Windows Me, please restart your computer before inserting the Adatper).
9. You may now see the WLAN 802.11g Cardbus shortcut on windows system
tray.
10
Loading...
+ 24 hidden pages