Wistron NeWeb KTHDP1 Users manual

High Definition Radio Plug & Play

Model: KT-HDP1

Installation & User Guide

2007 May

W arning and Safety Information

FCC Wa rning

This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless the
modifications are expressly approved in this user guide. The user could lose
the authority to operate this equipment if an unauthorized change or
modification is made.

FCC Compliance

This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

Consult the dealer or an experienced radio technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operation in
conjunction with any other antenna or transmitter.

2

General Precautions

Liquid Crystal Precautions

If the LCD screen on the receiver is damaged, do not to touch the liquid crystal
fluid. If any of the following situations happen, take the action indicated:

․ If the liquid crystal fluid comes in contact with your skin, wipe the

skin area with a cloth and then wash the skin thoroughly with
soap and running water.

․ If the liquid crystal fluid gets into your eye, flush the eye with

clean water for at least 15 minutes. Seek medical care.

․ If the liquid crystal fluid is ingested, flush your mouth thoroughly

with water. Drink large quantities of water and induce vomiting.
Seek medical care.

Safety Precautions

Be sure to observe the following warnings. Failure to follow these safety
instructions and warnings may result in a serious accident.

․ Do not operate the receiver in a way that might divert your

attention from driving safely. As a driver, you alone are
responsible for safely operating your vehicle in accordance with
traffic safety laws at all times.

․ Do not install the receiver where it may obstruct your view

through the windshield, or of your vehicle’s indicator displays.

․ Do not install the receiver where it may hinder the function of

safety devices such as an airbag. Doing so may prevent the
airbag from functioning properly in the event of an accident.

․ Be sure the receiver and accessories are installed as described

in the installation instructions which accompany each accessory
kit.

․ To avoid short circuits, do not open the receiver or accessories,

and never put or leave any metallic objects (coins, tools, etc.)
inside the receiver.

․ If the receiver or accessories emits smoke or unusual odors, turn

the power off immediately, and disconnect the receiver from any
power source.

․ Do not drop the receiver or subject it to strong shocks.

․ If the receiver doesn’t seem to be working properly, turn the

receiver off, wait 10 seconds, replace the battery and then turn it

3

on again.
The installation and use suggestions contained in this manual are
subject to any restrictions or limitations that may be imposed by
applicable law. The purchaser should check applicable law for any
restrictions or limitations before installing and/or operating this unit.

Warnings

Operating Temperature

The receiver is designed to operate between –20oC to +85oC.
Avoid leaving the receiver in a vehicle or elsewhere where the temperature
may fall outside this range. Extreme temperatures or extreme temperature
fluctuations can degrade the performance of the LCD display screen, and
possibly damage it.

Cleaning and Maintenance

If the receiver or accessories become dirty, turn the power off and wipe it clean
with a soft cloth. Do not use hard cloths, strong cleaning fluids, paint thinner,
alcohol, or other volatile solvents to clean. These may cause damage to the
receiver.

4