Page 1
INSTALLATION
INSTRUCTIONS
Wiremold Electrical Systems conform to and
should be properly grounded in compliance with
requirements of the current National Code or
codes administered by local authorities.
All electrical products may represent a possible
shock or fire hazard if improperly installed or
used. Wiremold electrical products are UL listed, made for interior use in dry locations only
and should be installed in conformance with current local and/or the National Electrical Code.
TPB Gasketed Box
The Wiremold Company
60 Woodlawn Street, P.O. Box 332500
West Hartford, CT 06133-2500
Tel. (203) 233-6251 Fax 203-232-2062
40775 294
1. Remove cover to power
compartment (optional).
2. Remove entrance end fitting
by loosening two retaining
screws (only if necessary).
3. Attach Gasket to bottom of box.
4. Insert power wires through
Gasketed Box (small opening).
5. Install Gasketed Box and divider
with two self-tapping screws to
top of pole. Fasten Gasketed
cover with four machine screws
to top of box.
6. Replace power cover.
7. Install power pole per
instructions (included with
power pole).
USED WITH:
25DTP Series
AMDTP Series
Cover mtg. screws
Gasketed box cover
Divider & box
mtg. screws
Divider
Box
Gasket
Aluminum or steel
power pole
Power compartment cover
Loading...