Page 1
1. Position floor boxes in desired
location (see Figure A). Floor
box minimum spacing is 6"
[152mm] on center.
NOTE: Do not position floor boxes
within this minimum spacing.
2. Connect conduits to box using
appropriate conduit adaptors
(not supplied by Walker (see
Figure B).
3. Attach box cover. Align
notches on one side of cover
with box tabs and strike other
side of cover with a mallet to
snap into place (see Figure C).
4. Adjust to desired level
of concrete pour using
the four adjusting screws.
5. Anchor box to form/subfloor.
Cat. Nos. 885B and 886B should
be secured with wire. Cat. Nos.
887B and 889B may be secured
with nails or screws.
6. Pour concrete to top of floor box.
880 Series Floor Box
INSTALLATION INSTRUCTIONS
Walker® electrical systems conform to
and should be properly grounded in
compliance with requirements of the
current National Electrical Code or codes
administered by local authorities.
All electrical products may present a
possible shock or fire hazard if improperly
installed or used. Walker electrical products may bear the mark as UL Listed
and/or Classified and should be installed
in conformance with current local and/or
the National Electrical Code.
Figure A
Figure B
Figure C
Adjusting Screw
Products Covered: 885B, 886B, 887B, and 889B
Walker Systems, Inc.
1000 Innovation Drive, Williamstown, WV 26187
IA0029 0200
© Copyright 2000 The Wiremold Company All Rights Reserved
Loading...