Page 1
Legrand/Wiremold electrical systems conform to and should be properly grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold electrical products
may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
OmniBox™Series Floor Boxes
I N S T A L L A T I O N I N S T R U C T I O N S
nstallation Instruction No.: IA0030R3 – Updated June 2012
I
Products Covered:
Steel Floor Boxes – 880M1, 880M2, 880M3 (Shallow), and 880S1, 880S2, 880S3 (Deep)
Cast Iron Floor Boxes – 880CM1-1, 880CM2-1, 880CM3-1 (Shallow), and 880CS1-1, 880CS1-NA, 880CS2-1,
FLOOR BOX INSTALLATION:
1. Determine box and conduit layout.
2. Remove required knockouts and attach
conduit with fittings.
3. Barrier must be installed if more than
one service is used.
880CS2-NA, 880CS3-1, 880CS3-NA (Deep)
Cat No. 880S2 Shown
IMPORTANT: Please read all instructions
before beginning.
CONCRETE PREPARATION:
1. Install concrete mud cap.
2. Adjust box height to 1/16" [1.59mm]
below screed line.
3. Secure box into position with
screws or rebar and pour concrete.
WIREMOLD
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
© Copyright 2012 Legrand/Wiremold All Rights Reserved
IA0030R3 0612
Loading...