Page 1
1. Remove existing ring by
turning adjusting screws
counter-clockwise until
ring sub-assembly lifts
off floor box.
2. Replace with new adjusting
ring by turning adjusting
screws clockwise.
Three adjusting screws
Existing Floor Box in Slab
Old Style Ring
New Style Ring
880ADP
Retrofit Kit for 885, 886, 887, and 889;
Floor Boxes to fit with 893 and 894;
Floor Box Activation Covers
INSTALLATION INSTRUCTIONS
Walker® electrical systems conform to and should be
properly grounded in compliance with requirements
of the current National Electrical Code or codes
administered by local authorities.
All electrical products may present a possible shock
or fire hazard if improperly installed or used. Walker
electrical products bear the mark as UL Listed and/or
Classified and should be installed in conformance with
current local and/or the National Electrical Code. Look
for listing and/or classification mark on product label.
Walker Systems, Inc.
1000 Innovation Drive, Williamstown, WV 26187
1 000 095 0900© Copyright 2000 The Wiremold Company All Rights Reserved
Loading...