Page 1
Impedance Matching Speaker
Selector
User Manual
2
Introduction
The Wired Home SS4, SS6 and SS8 are low-profile
speaker selectors that allow you to distribute a
stereo speaker-level (amplified) signal to multiple
listening zones. These speaker selectors feature a
manually activated impedance protection circuit.
The protection switch can be turned ON to prevent
the impedance to your amplifier from dropping
below 5 Ohms, regardless of the number and
impedance ratings of your speakers. The protection
switch can be turned OFF when used as part of a
system incorporating impedance matching volume
controls, allowing you to get the most out of your
amplifier.
The terminals on the rear of the speaker selector
will accommodate up to 14 gauge cable; sufficient
for cable runs exceeding 100 feet. For shorter
distances, 16 ~ 18 gauge cable will suffice. For inwall installations, we recommend using CL-2 or
CL-3 rated cable for compliance with local building
codes. If unsure, contact you local building
inspector. When connecting a speaker and
amplifier, it is important to maintain polarity;
positive (+/red) to positive and negative (-/black) to
negative. Be careful to maintain correct polarity
between the amplifier, the speaker selector, the
volume controls and the speakers.
Page 2
3
Installation
• Route speaker cables from each listening zone to
the speaker selector
• Route speaker cables from the amplifier to the
speaker selector
• Remove approximately 8" of the outer jacket from
speaker cable (if necessary)
• Strip approximately 3/8" of insulation from each
conductor and twist the exposed strands together
to avoid fraying
• Press the push terminal and insert the conductor;
release to make contact
• Set Impedance Protection to ON or OFF as
necessary
4
Specifications
Protection
Circuit
Power
Protection
OFF
Power
Protection
ON
Dimensions
SS4
2 x 10 ohm
15
watts/channel
140
watts/channel
70
watts/channel
8.5" x 4.4" x
1.93"
SS6
2 x 10 ohm
15
watts/channel
140
watts/channel
70
watts/channel
17" x 4.4" x
1.93"
SS8
3 x 10 ohm
15 watt/channel
200
watts/channel
100
watts/channel
17" x 4.4" x
1.93"
Warranty
This Wired Home product is warranted free from defects in
material and workmanship for a period of One Year from the
date of purchase. Wired Home will at their discretion, repair,
replace or credit the faulty unit unless otherwise specified by
contractual agreement. Any faulty unit that is no longer in
production will be replaced with a similar or equivalent unit.
Warranty registration is not required, but purchasers are asked
to retain their receipt as proof of purchase. Warranty does not
apply to misuse, abuse, neglect, accident, improper use, etc.
Loading...