Wintex Agro 1000 Instruction Manual

Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted

[phone], [e-mail], www.wintexagro.com

INSTRUCTION MANUAL WINTEX 1000

 0-25 cm
 Fully automatic
 Fast and efficient
 Optimum speed
 Minimum maintenance
 Reliable
 Competitive

INTEGRATED HYDRAULICS

201605

P A G E | 1

Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted

[phone], [e-mail], www.wintexagro.com

Manufactured by: WINTEX AGRO

Vilhelmsborgvej 15
DK-7700 Thisted

Type designation: WINTEX 1000

Voltage: 12 volt DC

Year of production: 2016

FOR YOUR SAFETY

Before starting the WINTEX1000 please make sure that nobody is present within a range of 10 meters.

Be seated correctly on the ATV with one leg on each side of the seat, and the hands placed correctly on the steering wheel.

When inspecting the WINTEX 1000, you must always activate the emergency stop, and the ATV must be turned off.

Every time you start the WINTEX 1000, you must test the emergency stop. If the emergency stop does not turnoff the soil sampler, you

must not use it.

P A G E | 2

Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted

[phone], [e-mail], www.wintexagro.com

1. STARTING THE WINTEX 1000

2. INTERRUPTING THE PROCESS

3. REPLACEMENT OF PROBE

P A G E | 3

Start the ATV, and deactivate the emergency stop. The red button must be up.

Activate the foot switch and the brake handle on the steering wheel, and shortly push the button
at your right hand. Foot switch and brake lever must be activated during the entire process. If
one of these switches is released, the process will stop.

Note: The emergency stop must always be activated at long stops, or the battery might be
discharged.

The WINTEX 1000 has three programs.
Program 1: The soil sampler’s standard program.
Program 2: The probe conducts an extra rotation.
Program 3: The probe moves up and down without rotation.

Due to various reasons it might be necessary to interrupt the process. In this case deactivate the foot
switch, and the process will stop immediately. When reactivating the foot switch and the brake handle
at the same time, the probe will go back into start position.

The emergency stop must be activated, and the ATV must be turned off.

Use two 27 mm keys to loosen the probe.

The probe is mounted correctly when the slit of the probe points towards the soil box when the rotation
stops.