Wintal A-1247DWP Instruction Manual

HDTV Over Cat5 Distribution System With IR Instruction Manual

The System allow the extension of component video, digital audio stereo audio and
infrared control signals using two Cat5 UTP (category 5, unshielded twisted pair) cables.
The System uses a unique method of transparent data transfer, which allows a device,
such as DVD player, set-top box to be situated up to 400ft (120m) away from the
controller TV or point of control.
Fully compliant with standard 38 kHz modulated IR or higher, the IR extender link will
provide a transparent path for all protocols and data transfers.
The Distribution Hub has one set of RCA inputs and one set of RCA loop-thr u connectors
to go to the next Distribution Hub if installed. The System allows any HDTV audio/video
source to distribute audio and video to 4-zone distant locations with excellent picture
quality.
The AV Cat5 Receiver supports one monitor with component video, stereo audio.

Related Components:

Distribution Hub

Dual Band IR

Receiver

Switching Power
(12VDC, 1.2A or above)

HDTV Over Cat5 Receiver

Dual And

Single IR Emitter

FEATURES

1. Four zone distribution ability &
Loopout function.

2. Three emitters output & IR Link
connections. (Mono or stereo plug)

3. Convenient IR confirmation LED.

4. Power receptacle with LED indicator.

SPECIFICATIONS

1. Video nominal input level:1 Volt
(peak to peak)

2. Video input impedance

(Distribution Hub):75 ohm.

3. Video output impedance

(AV Cat5 Receiver):75 ohm.

4. Audio input impedance

(Distribution Hub):47K ohm.

5. Audio output impedance

(AV Cat5 Receiver):300 ohm.

5. Supports 480p,720p,1080i,1080p
resolutions

6. Sends component Video, digital audio
Ster eo Audio, IR signals and Power
over two CAT5.

6. Distance: reaches up to 400 feet
(120 m).

7. Power: Switching Power 12VDC

/ 1.2A

8. Weight

Distribution Hub: 460 g
HDTV Over Cat5 Receiver:85g

9. Dimensions

Distribution Hub:

195L x 87W x 27H mm

HDTV Over Cat5 Receiver

115L x 75W x 56H mm

INSTALLATION

1. Connecting Distribution Hub to the AV sources. (DVD, VCR, satellite receiver etc.)

2. Connect AV CAT5 Receiver to the Display.

3. Connect the Distribution Hub to the AV Cat5 Receiver using Cat5 UTP cable (Purchased
separately). The Cat5 UTP cable, if purchased in bulk, will be wired using 568A or 568B
wiring standard as shown in the table blow. Once connected, check that the power LEDs
on both the Distribution Hub and the AV Cat5 Receiver are on, IR LED is flashing when
remote control is used indicating that communication is in progress.

CAUTION: Do not plug the Switching Power to Distribution Hub unless all installation be
finished, otherwise the surge-current could damage the A V Cat5 Receiver.