Wintal A-1176 Installation Manual

In-Wall S-Video/Stereo Audio CAT5 Extender Manual A-1176

The A-1176 is the next step in the evolution of home
theater and residential audio/video components. This
module will provide crystal clear sound and pictures over
long distances utilizing economical Category 5e or higher
UTP cable.

SPECIFICATIONS:

Interface:

Video: 1x S-Video female connector
Audio: 2x RCA jacks for Le ft and Right Audio
UTP: 110-type rear punchdown

Impedance:

Video: 100 ohm Unbalanced
Audio: 600 ohm Unbalanced

Bandwidth:

Video: DC~12 MHz
Audio: 50 Hz~15 KHz

Distance:

Audio/Color Video: Category 5e UTP cable up to

300 meters

IMPORTANT

Do not route audio/video cables through the ‧
same cable holes as the AC power cables.
For safety, all audio/video cables sho‧ uld be
separated from parallel AC power lines by at
least 6 inches whenever possib le.
Avoid kinking the cable.‧
Do not attach cable tie‧ -downs too tightly. The
cable fastening hardware should not compress
the cable sheath.
Do not bend the cable sharply. ‧ Be especially

careful to dress the cables properly after

passing them through a hole as the edges of
the hole can compress or even damage the

cable sheath.
Follow all warnings on the products.‧
For your safety, do not use this or any electrical‧
product near water (unless specifically designed
for wet areas).
Do not install wiring during thunder and lightning‧
storms.
Use caution when handling or installing any‧
computer, telephone, video, or electrical devices.

INSTALL ATION

1. Strip off approximately 2" of the Category 5e
cable jacket, using the appropriate cable
stripping tool.

2. Separate the pairs according to color (Brown/
Brown-White, Green/Green-White, Orange/
Orange-White, and Blue/Blue-White).

3. To terminate, place each wire into the insulation

displacement contacts (IDC) by matching the wire
color with the applicable colors on the punchdown
block.(see the figure below).

TIP: We recommend untwisting the pairs no more than 1"

from termination point.

4. If using a 110-type punchdown tool, place the tool over

each wire with the cutting blade facing outside of the
IDC and punch down firmly.

5. Repeat this process with each pair.

6. Install included termination caps firml y onto the IDC.

7. Fasten insert and wallplate to electrical box using

supplied screws.