Page 1
ASSEMBLY INSTRUCTION
___________
RS TABLE TOP 10 MOUNTING PLATE M PEDESTAL COLUMN ID PEDESTAL LEG
1 PC 1 PC 1 PC 4 PCS
10 ALLEN WRENCH t f JCBC M6 x 50mm [f l SPRING WASHER M6 |£ | FLAT WASHER M6
) OVAL DINING TABLE WITH 18" EXTENSION LEAF ______________________
(Unloose from step 1) _
(Included 4 pcs from step 1) (Included 4 pcs from step 1) (Included 4 pcs from step 1)
r -" {¡¡f®0 &
1 PC
____________
11 WRENCH 13mm U HEX NUT 5/16" (O SPRING WASHER M8 |f l FLAT WASHER M8 x 2mm
1 PC 12 PCS 12 PCS 12 PCS
m LEVELER
4 PCS
6 PCS
____________
6 PCS_____________ 6 PCS
___________
This Page lists all the contents included
in the box . Please take the time to
identify the hardware as
well as the individual components to this
product. As you unpack and prepare for
assembly, place
the contents on a carpeted or padded
area to protect them from damage .
1
Page 2
Please unloose bolt, spring washer and flat washer from mounting plate(B)
1
with Allen wrench(E). Keep the hardware for step 3 use and mounting plate
for step 2 use.
Align and fasten mounting plate(B) to pedestal column(C) using hex nut(J),
big spring washer(K) and big flat washer(L) and tighten with wrench(I).
** Do not fully tighten the nut or bolt until all nuts and bolts are attached.
2
Page 3
Place table top upside down on soft surface. Align and fasten
mounting plate(B) to table top(A) using bolt(F), small spring washer(G) and
small flat washer(H) and tighten with Allen wrench(E).
** Do not fully tighten the nut or bolt until all nuts and bolts are attached.
El Screw in the levelerfM) to the bottom of pedestal legfDF Align and fasten
pedestal leg(D) to pedestal column(C) using hex nut(J),
big spring washer(K), and big washer(L) and tighten with wrench(I).
3
Page 4
Flip table over using two people to lift and flip the table. Unlock the latches
underneath table top(A). Pull apart the table top(A) at both ends and take
out the center leaf.
Push both ends together and make sure pin line up. Close the table top(A)
tightly and lock all latches on the underneath of the table.
A
Stand table up on an even surface and check
that it is balanced. If there is a slight wobble,
please adjust the leveler.
Cleaning & Care
Treat Surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surface with a
dry or damp soft cloth. Do not use abrasive cleaners . Hardware may loosen over time. Periodically check
that all connections are tight.
4
Loading...