Page 1
Caution : You must read this before you proceed
Sofa
Picture
Label Picture Description QTY
A Backrest 1
B Seat 1
C Leg 4
Page 1 OF 6
Page 2
Label Picture Description QTY
①
Bolt (M8*60MM) 7
②
Spring Washer 7
③
Washer 7
④
Allen Key 1
⑤
Gasket 7
Before
Beginning
Assembly:
Page 2 OF 6
Page 3
Overview
This Sofa has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Sofa parts, the above picture is
to help you put the various parts into perspective. Please read through
the instructions below to familiarise yourself with the parts and steps
before assembly.
Step 1
Open up the carton and place all parts onto a clean, non-marring surface.
1.1Then open up the Seat(B).
1.2Remove the Backrest(A),Legs(C) and hardware.
Backrest(A)
Seat(B)
Leg(C)
FRONT FACING
Page 3 OF 6
Page 4
Step 2
With the seat(B) open,align Backrest(A) and the open Seat(B) as shown
in the picture.
2.1Attach middle mounting position of Seat(B) and Backrest(A) using
Bolts(①), Spring Washers(②), and Washers(③) with Allen Key(④).
Do not fully tighten the Bolts.
Repeat the same process to attach the remain mounting position.
2.2After 6 bolts aligned,tighten all Bolts(①) with Allen Key(④) fully in a
sequential manner.
2.3Then close the seat(B) as shown in the picture.
Step 3
⑤
C
step2.1
step2.3
step2.2
Page 4 OF 6
Page 5
Install Leg(C) to Seat(B) by first placing a Gasket(⑤) onto the threaded
stem of the Leg(C).
Then insert the Leg(C) into the corner of the base of the Seat(B). Tighten
by turning Leg(C) clockwise by hand.
Repeat the same process to install the remaining three Legs(C).
Note: The use of Gaskets is optional. They are especially useful for
alleviating slight wobbles from the Sofa. Some Legs may require
more than one Gasket whilst some Legs may not require any.
Step 4
Stand the Sofa up.
Your Sofa is ready for use.
This Sofa can only be used on a flat, level surface.
Page 5 OF 6
Page 6
Page 6 OF 6
Loading...